- Area
- Hampshire
- Postcode district
- BH24
- Nation
- England
- Guide price
- From £9,800 inc VAT
- Survey
- Free for installation enquiries
Before you book: air source heat pump installation in Ringwood
Most homes can run on a heat pump if the system is designed properly, and Ringwood is no different. The key is matching the heat pump and radiators to the home's heat loss.
In Ringwood, cylinder space is planned with you, often in an airing cupboard, utility room or garage. Terraced streets in Ringwood often mean a compact unit position at the rear, so siting and sound levels are checked carefully.
We survey your home, design a heat pump system around its real heat loss, and manage the installation from the first visit to the MCS certificate.
- Houses with reasonable insulation, or a plan to improve it
- Owners and landlords in England and Wales eligible for the Boiler Upgrade Scheme
- Homes replacing a gas, oil, LPG or electric heating system
What's included
- Free home survey and room-by-room heat loss calculation
- Removal of the old boiler or heaters
- Outdoor unit, hot water cylinder and weather compensation controls
- Radiator and pipework changes where the design needs them
- Commissioning, handover and a walk-through of the controls
Homeowners across Hampshire can arrange a survey in Ringwood for a room-by-room design and a written quote before committing to anything.
Grants and rules for heat pumps in England
In England the Boiler Upgrade Scheme gives £7,500 towards an air source heat pump (£9,000 if it replaces oil or LPG, from 21 July 2026 to 31 March 2027), and since 28 April 2026 a valid EPC is no longer needed. The grant is applied for by the MCS-certified installer and shown as a deduction on your Ringwood quote.
There is no VAT on installing a heat pump anywhere in the UK until 31 March 2027. In England most houses can have an air source heat pump under permitted development, provided the unit meets the MCS noise and siting standards; the old 1 m boundary limit was removed on 29 May 2025. We flag listed buildings, flats and sensitive conservation-area positions at survey.
Air source heat pump installation prices in Ringwood
The ranges below are typical installed prices for homes in Hampshire, including VAT. A survey sets the exact figure, because two similar-looking houses in Ringwood can need quite different radiators and pipework.
| Home | Typical size | Installed guide price | After £7,500 grant |
|---|---|---|---|
| 1–2 bedroom flat or small terrace | 4–5 kW | £9,800–£12,900 | £2,300–£5,400 |
| 2–3 bedroom terrace or semi | 5–7 kW | £10,800–£13,900 | £3,300–£6,400 |
| 3 bedroom semi or small detached | 6–9 kW | £12,350–£15,950 | £4,850–£8,450 |
| 4 bedroom detached | 8–12 kW | £14,400–£18,550 | £6,900–£11,050 |
| 5+ bedroom or larger older house | 11–16 kW | £17,000–£23,200 | £9,500–£15,700 |
Installed, inc VAT: unit, cylinder, controls, minor pipework and commissioning.
How long is the heating season in Ringwood?
On the shortest day Ringwood gets about 7 hours 56 minutes of daylight, and the winter sun reaches only around 16° above the horizon at noon. Winters this far south are milder than in most of the UK, which helps a heat pump run at low flow temperatures for much of the season.
The steps for air source heat pump installation in Ringwood
- Send your postcode and a few details, or use the guide price tool.
- A surveyor visits your Ringwood home, measures every room and checks where the outdoor unit can go.
- You receive a heat loss design and a fixed written quote, with any grant shown where it applies.
- Installers fit the unit, cylinder and any radiator changes, typically over 2–4 days on site.
- The system is commissioned, set up with weather compensation and handed over with the paperwork.
Air source heat pump installation in Ringwood: questions
Do I need new radiators for a heat pump in Ringwood?
Often some, not all. Heat pumps run best at lower water temperatures, so rooms with small radiators may need larger ones. The survey of your Ringwood home gives a room-by-room list.
Can you service a heat pump in Ringwood that someone else installed?
Yes. We arrange servicing and repairs for most air source heat pumps in Ringwood, whoever fitted them. Tell us the make and model when you book.
How long does a heat pump survey take in Ringwood?
A home survey in Ringwood usually takes one to two hours. The surveyor measures every heated room, checks windows, walls and radiators, and looks at where the outdoor unit and cylinder can go.
Do I need new radiators for a heat pump?
Not always; many homes keep most of their radiators and change only a few. Because a heat pump runs at a lower water temperature than a boiler, each radiator gives out less heat, so the survey checks every room against its heat loss. Rooms where the existing radiator falls short get a larger one, with a guide price of £250–£450 each, installed and including VAT.
Can I cancel after accepting the quote?
Nothing is ordered until you accept the written quote. Where the contract is agreed away from our premises, for example at your kitchen table, you can cancel within 14 days under the Consumer Contracts Regulations 2013. If you ask us to start sooner and then cancel, you pay only for work done up to that point.