- Area
- Isle of Wight
- Postcode district
- PO36
- Nation
- England
- Guide price
- From £10,050 inc VAT
- Survey
- Free for installation enquiries
What to know about replacing a gas boiler with a heat pump in Sandown
In Sandown, as anywhere in the UK, the heat pumps that perform well are the ones designed around low flow temperatures and sized from a proper heat loss calculation.
Many gas-heated homes in Sandown have a combi boiler in the kitchen, so the survey starts by finding the right place for a cylinder. Households across the Isle of Wight moving off gas can have a survey in Sandown that compares running costs on realistic assumptions.
Moving from mains gas to a heat pump means finding cylinder space, deciding what happens to the gas supply and comparing running costs on realistic assumptions.
- Boilers that are old, unreliable or due for replacement
- Households ready to give up gas entirely and drop the standing charge
- Combi owners who can find space for a hot water cylinder
What's included
- System flush and radiator upgrades where the design calls for them
- Heat pump cylinder, outdoor unit and weather compensation controls
- Free survey with heat loss calculation and cylinder siting
- Capping of the gas pipe at the boiler position where you are giving up gas
- Commissioning, MCS certificate and grant application in England and Wales where eligible
If your Sandown home still cooks on gas, we talk through whether to keep the supply or switch to an induction hob.
Grants and rules for heat pumps in England
In England the Boiler Upgrade Scheme gives £7,500 towards an air source heat pump (£9,000 if it replaces oil or LPG, from 21 July 2026 to 31 March 2027), and since 28 April 2026 a valid EPC is no longer needed. The grant is applied for by the MCS-certified installer and shown as a deduction on your Sandown quote.
Installing heat pumps is zero-rated for VAT across the UK until 31 March 2027. Since 29 May 2025, permitted development in England allows up to two air source heat pumps on a house, each up to 1.5 m³, with no blanket 1 m boundary rule — the installation must still meet the MCS planning standards, including the noise check. Listed buildings, flats and some conservation-area positions need extra consent, which we check at survey.
Guide prices for replacing a gas boiler with a heat pump in Sandown
The ranges below are typical installed prices for homes in the Isle of Wight, including VAT. A survey sets the exact figure, because two similar-looking houses in Sandown can need quite different radiators and pipework.
| Home | Typical size | Installed guide price | After £7,500 grant |
|---|---|---|---|
| 1–2 bedroom flat or small terrace | 4–5 kW | £10,050–£13,250 | £2,550–£5,750 |
| 2–3 bedroom terrace or semi | 5–7 kW | £11,150–£14,300 | £3,650–£6,800 |
| 3 bedroom semi or small detached | 6–9 kW | £12,700–£16,450 | £5,200–£8,950 |
| 4 bedroom detached | 8–12 kW | £14,850–£19,100 | £7,350–£11,600 |
| 5+ bedroom or larger older house | 11–16 kW | £17,500–£23,850 | £10,000–£16,350 |
Installed, inc VAT: unit, cylinder, controls, minor pipework and commissioning.
Designing for Sandown's winters
Sandown sees roughly 7 hours 58 minutes of daylight in late December against 16 hours 29 minutes in June. Milder southern winters suit heat pumps well, though the system is still sized for a cold snap rather than an average day.
From survey to switch-on in Sandown
- Send your postcode and a few details, or use the guide price tool.
- A surveyor visits your Sandown home, measures every room and checks where the outdoor unit can go.
- You receive a heat loss design and a fixed written quote, with any grant shown where it applies.
- Installers fit the unit, cylinder and any radiator changes, typically over 2–4 days on site.
- The system is commissioned, set up with weather compensation and handed over with the paperwork.
Replacing a gas boiler with a heat pump in Sandown: questions
Where would the outdoor unit go on a Sandown house?
Usually at the side or rear, on a level base with space around it for airflow and servicing, away from bedroom windows where possible. The surveyor checks positions at your Sandown home.
How long does a heat pump survey take in Sandown?
A home survey in Sandown usually takes one to two hours. The surveyor measures every heated room, checks windows, walls and radiators, and looks at where the outdoor unit and cylinder can go.
How soon can you survey a home in Sandown?
Survey dates depend on how busy installers are in the Isle of Wight. We offer the next available dates when you enquire and confirm them in writing.
Can a heat pump replace a combi boiler?
Yes, but you need room for a hot water cylinder, because heat pumps store hot water rather than heating it on demand. Most homes find a space in a cupboard, utility room, garage or under the stairs, and compact or combined indoor units help where space is tight. The survey measures the options first, so you know where everything will go before you accept the quote.
Do I need to replace the cylinder I already have?
Usually, yes. Older cylinders have a small internal coil designed for water from a boiler at around 60–70°C, and they cannot take in heat quickly enough at the lower temperatures a heat pump runs at. A heat pump cylinder has a larger coil. On its own, a cylinder supplied and fitted has a guide price of £1,200–£2,200, installed and including VAT, though it is normally part of the full system price.