- Area
- Oxfordshire
- Postcode district
- OX10
- Nation
- England
- Guide price
- From £9,900 inc VAT
- Survey
- Free for installation enquiries
Gas boiler to heat pump in Wallingford: what to expect
The question for a Wallingford home is rarely whether a heat pump can work, but what needs to change to make it work well: radiator sizes, pipework, controls and where the unit goes.
Installers in Wallingford take out the old boiler and flue and seal the wall opening as part of the job. Rear gardens and side returns in Wallingford usually offer a sensible spot for the outdoor unit, checked for airflow and neighbours.
Moving from mains gas to a heat pump means finding cylinder space, deciding what happens to the gas supply and comparing running costs on realistic assumptions.
- Households ready to give up gas entirely and drop the standing charge
- System or regular boiler homes with an existing airing cupboard
- Homes in England and Wales eligible for the Boiler Upgrade Scheme
What's included
- Removal of the gas boiler, flue and any loft tanks
- Commissioning, MCS certificate and grant application in England and Wales where eligible
- Capping of the gas pipe at the boiler position where you are giving up gas
- Free survey with heat loss calculation and cylinder siting
- Heat pump cylinder, outdoor unit and weather compensation controls
If your Wallingford home still cooks on gas, we talk through whether to keep the supply or switch to an induction hob.
Grants and rules for heat pumps in England
Homes in Wallingford can use the Boiler Upgrade Scheme, which takes £7,500 off the cost of an air source heat pump when it replaces fossil-fuel or electric heating. Replacing oil or LPG heating qualifies for £9,000 for installations from 21 July 2026 to 31 March 2027, and air-to-air systems for £2,500. The MCS-certified installer named in your quote applies for the grant and deducts it from the price.
There is no VAT on installing a heat pump anywhere in the UK until 31 March 2027. In England most houses can have an air source heat pump under permitted development, provided the unit meets the MCS noise and siting standards; the old 1 m boundary limit was removed on 29 May 2025. We flag listed buildings, flats and sensitive conservation-area positions at survey.
Gas boiler to heat pump costs around Wallingford
Here are typical prices for replacing a gas boiler with a heat pump in Oxfordshire, installed and including VAT. Use the guide price tool for a figure based on your home, then a survey confirms it in writing.
| Home | Typical size | Installed guide price | After £7,500 grant |
|---|---|---|---|
| 1–2 bedroom flat or small terrace | 4–5 kW | £9,900–£13,000 | £2,400–£5,500 |
| 2–3 bedroom terrace or semi | 5–7 kW | £10,900–£14,050 | £3,400–£6,550 |
| 3 bedroom semi or small detached | 6–9 kW | £12,500–£16,100 | £5,000–£8,600 |
| 4 bedroom detached | 8–12 kW | £14,550–£18,700 | £7,050–£11,200 |
| 5+ bedroom or larger older house | 11–16 kW | £17,150–£23,400 | £9,650–£15,900 |
Installed, inc VAT: unit, cylinder, controls, minor pipework and commissioning.
Designing for Wallingford's winters
On the shortest day Wallingford gets about 7 hours 49 minutes of daylight, and the winter sun reaches only around 15° above the horizon at noon. Winters this far south are milder than in most of the UK, which helps a heat pump run at low flow temperatures for much of the season.
The steps for replacing a gas boiler with a heat pump in Wallingford
- Send your postcode and a few details, or use the guide price tool.
- A surveyor visits your Wallingford home, measures every room and checks where the outdoor unit can go.
- You receive a heat loss design and a fixed written quote, with any grant shown where it applies.
- Installers fit the unit, cylinder and any radiator changes, typically over 2–4 days on site.
- The system is commissioned, set up with weather compensation and handed over with the paperwork.
Replacing a gas boiler with a heat pump in Wallingford: questions
What size heat pump does a Wallingford home need?
It depends on the heat loss, not the postcode. As a rough guide, a 3 bedroom semi often needs 6–9 kW, but the room-by-room survey sets the actual size for your Wallingford home.
Can you service a heat pump in Wallingford that someone else installed?
Yes. We arrange servicing and repairs for most air source heat pumps in Wallingford, whoever fitted them. Tell us the make and model when you book.
Do you cover Didcot as well as Wallingford?
Yes. We arrange surveys and installation in Didcot, which is about 5 miles west of Wallingford, and across Oxfordshire.
Do I need to replace the cylinder I already have?
Usually, yes. Older cylinders have a small internal coil designed for water from a boiler at around 60–70°C, and they cannot take in heat quickly enough at the lower temperatures a heat pump runs at. A heat pump cylinder has a larger coil. On its own, a cylinder supplied and fitted has a guide price of £1,200–£2,200, installed and including VAT, though it is normally part of the full system price.
Can a heat pump replace a combi boiler?
Yes, but you need room for a hot water cylinder, because heat pumps store hot water rather than heating it on demand. Most homes find a space in a cupboard, utility room, garage or under the stairs, and compact or combined indoor units help where space is tight. The survey measures the options first, so you know where everything will go before you accept the quote.