- Area
- Cheshire
- Postcode district
- SK9
- Nation
- England
- Guide price
- From £90 inc VAT
- Visit
- Rate agreed in advance
Heat pump repairs in Alderley Edge: what to expect
Whoever installed your heat pump, aftercare can be arranged in Alderley Edge. Tell us the make and model and roughly how old it is, and we will set out what the visit involves before you book.
Repairs in Alderley Edge that need a part ordered are explained and priced before the engineer leaves. Outdoor units in exposed spots around Alderley Edge can ice more heavily, so siting is checked as part of any icing fault.
When a heat pump shows an error, loses pressure or stops heating, an engineer diagnoses the cause and explains the repair and its cost before fixing it.
- Outdoor units that have become noisy, iced up or keep switching on and off
- Rooms or hot water not getting warm enough
- Heat pumps installed by another company that need a second opinion
What's included
- Fault-finding visit at a rate agreed before attending
- Testing of sensors, pumps, valves, pressures and electrics
- System refill, venting and recommissioning after the repair
- A clear explanation of the fault and a price for the repair before work goes ahead
- Refrigerant repairs by an F-gas certified engineer where needed
We repair heat pumps in Alderley Edge whoever installed them, including older monobloc and split systems.
Grants and rules for heat pumps in England
In England the Boiler Upgrade Scheme gives £7,500 towards an air source heat pump (£9,000 if it replaces oil or LPG, from 21 July 2026 to 31 March 2027), and since 28 April 2026 a valid EPC is no longer needed. The grant is applied for by the MCS-certified installer and shown as a deduction on your Alderley Edge quote.
Heat pump repairs costs around Alderley Edge
These are guide prices including VAT. The rate for your visit in Alderley Edge is confirmed before we book it, and any repair is priced in writing before parts are ordered.
| Repair | Guide price |
|---|---|
| Fault-finding visit and diagnosis | £90–£180 |
| Sensor or thermistor replacement | £120–£280 |
| Expansion vessel or pressure relief valve | £150–£350 |
| Circulating pump replacement | £250–£480 |
| Fan motor replacement | £300–£650 |
| Refrigerant leak repair and re-gas (split systems) | £350–£950 |
| Main control board (PCB) replacement | £450–£1,100 |
Inc VAT. The fault-finding rate is agreed before we attend; repairs are priced in writing before parts are ordered.
Winter daylight and heating in Alderley Edge
Alderley Edge has about 7 hours 30 minutes of daylight at midwinter and 17 hours 00 minutes at midsummer. That swing matters if you pair a heat pump with solar panels: summer generation can cover much of the hot water, winter generation far less.
Booking a visit in Alderley Edge
- Tell us the make if you know it, the error code or symptoms, and send photos of the unit and controller.
- We confirm the fault-finding rate and arrange a visit in Alderley Edge.
- The engineer diagnoses the fault and gives you a written price for the repair.
- Parts are ordered once you agree, and the repair is completed and tested.
Heat pump repairs in Alderley Edge: questions
What should I check before booking a visit in Alderley Edge?
Note any error code on the controller, check the system pressure gauge if you have one, and make sure the outdoor unit is clear of leaves or snow. Photos of the unit and controller help.
Will the engineer need access indoors as well as outside?
Usually yes. The outdoor unit, the hot water cylinder, the controls and the pipework and valves indoors are all part of the visit, so allow access to each.
Do you also cover Wilmslow?
Yes. We arrange heat pump servicing and repairs in Wilmslow, which is about 2 miles north of Alderley Edge, and across Cheshire.
Can you repair a heat pump installed by another company?
Yes. We carry out fault-finding and repairs on heat pumps installed by other companies, including monobloc and split systems. Tell us the make, model and approximate age when you get in touch, plus any error code shown. If the system is still under the manufacturer's warranty, it may be quicker to contact the original installer or manufacturer first.
Why does my heat pump keep switching on and off?
Frequent starting and stopping, called short cycling, is usually caused by an oversized heat pump, low water flow, too many zones closing at once or controls set with too narrow a range. It reduces efficiency and wears components. An engineer can check the settings, flow rates and design, and can often improve it with control changes before any parts are needed.