- Area
- County Tyrone
- Postcode district
- BT80
- Nation
- Northern Ireland
- Guide price
- From £90 inc VAT
- Visit
- Rate agreed in advance
What to know about heat pump repairs in Cookstown
Aftercare matters as much as installation. For a heat pump in Cookstown the visit checks the outdoor unit, the water circuit and the controls, and the engineer explains any settings that would help the system run more efficiently.
For repeated faults in Cookstown, the engineer looks at the system design as well as the failed part. Repairs in Cookstown that need a part ordered are explained and priced before the engineer leaves.
When a heat pump shows an error, loses pressure or stops heating, an engineer diagnoses the cause and explains the repair and its cost before fixing it.
- Heat pumps showing an error code or fault light
- Rooms or hot water not getting warm enough
- Systems losing pressure or needing frequent topping up
What's included
- Supply and fitting of replacement parts
- Reading of error history and operating data
- A clear explanation of the fault and a price for the repair before work goes ahead
- Testing of sensors, pumps, valves, pressures and electrics
- System refill, venting and recommissioning after the repair
We repair heat pumps in Cookstown whoever installed them, including older monobloc and split systems.
Grants and rules for heat pumps in Northern Ireland
Northern Ireland does not have a dedicated heat pump grant for homeowners at present, and the Boiler Upgrade Scheme does not apply here. Heat pumps have sometimes been funded through the Northern Ireland Sustainable Energy Programme, so it is worth checking what is open when you enquire about a home in Cookstown.
Guide prices for heat pump repairs in Cookstown
These are guide prices including VAT. The rate for your visit in Cookstown is confirmed before we book it, and any repair is priced in writing before parts are ordered.
| Repair | Guide price |
|---|---|
| Fault-finding visit and diagnosis | £90–£170 |
| Sensor or thermistor replacement | £120–£270 |
| Expansion vessel or pressure relief valve | £150–£340 |
| Circulating pump replacement | £240–£470 |
| Fan motor replacement | £290–£630 |
| Refrigerant leak repair and re-gas (split systems) | £340–£920 |
| Main control board (PCB) replacement | £440–£1,050 |
Inc VAT. The fault-finding rate is agreed before we attend; repairs are priced in writing before parts are ordered.
Short winter days in Cookstown and what they mean
Cookstown sees roughly 7 hours 14 minutes of daylight in December and 17 hours 17 minutes in June. With a longer heating season than the south, the gains from low flow temperatures and good controls add up over the year.
Booking a visit in Cookstown
- Tell us the make if you know it, the error code or symptoms, and send photos of the unit and controller.
- We confirm the fault-finding rate and arrange a visit in Cookstown.
- The engineer diagnoses the fault and gives you a written price for the repair.
- Parts are ordered once you agree, and the repair is completed and tested.
Heat pump repairs in Cookstown: questions
Do you also cover Coalisland?
Yes. We arrange heat pump servicing and repairs in Coalisland, which is about 7 miles south of Cookstown, and across County Tyrone.
Can you work on a heat pump in Cookstown that someone else installed?
Yes. We arrange servicing and repairs for most air source heat pumps in Cookstown, whoever fitted them. Tell us the make and model when you get in touch.
Will the engineer need access indoors as well as outside?
Usually yes. The outdoor unit, the hot water cylinder, the controls and the pipework and valves indoors are all part of the visit, so allow access to each.
Is ice on my heat pump a fault?
Some frost on the outdoor unit in cold, damp weather is normal, and the unit clears it with regular defrost cycles, often releasing a little vapour. It becomes a fault when thick ice builds up and does not clear, or when ice blocks the fan. That can point to poor airflow, a failed sensor, drainage problems or low refrigerant, and needs checking.
Can you repair a heat pump installed by another company?
Yes. We carry out fault-finding and repairs on heat pumps installed by other companies, including monobloc and split systems. Tell us the make, model and approximate age when you get in touch, plus any error code shown. If the system is still under the manufacturer's warranty, it may be quicker to contact the original installer or manufacturer first.