- Area
- Greater London
- Postcode district
- NW1
- Nation
- England
- Guide price
- From £100 inc VAT
- Visit
- Rate agreed in advance
Heat pump repairs for Camden homes
A heat pump that is serviced and set up properly keeps running efficiently for many years. Many heat pump faults trace back to settings, low pressure or a worn part rather than the heat pump itself, and those can usually be put right.
Outdoor units in exposed spots around Camden can ice more heavily, so siting is checked as part of any icing fault. For repeated faults in Camden, the engineer looks at the system design as well as the failed part.
When a heat pump shows an error, loses pressure or stops heating, an engineer diagnoses the cause and explains the repair and its cost before fixing it.
- Heat pumps showing an error code or fault light
- Systems losing pressure or needing frequent topping up
- Rooms or hot water not getting warm enough
What's included
- A clear explanation of the fault and a price for the repair before work goes ahead
- Reading of error history and operating data
- Refrigerant repairs by an F-gas certified engineer where needed
- System refill, venting and recommissioning after the repair
- Testing of sensors, pumps, valves, pressures and electrics
We repair heat pumps in Camden whoever installed them, including older monobloc and split systems.
Grants and rules for heat pumps in England
Homes in Camden can use the Boiler Upgrade Scheme, which takes £7,500 off the cost of an air source heat pump when it replaces fossil-fuel or electric heating. Replacing oil or LPG heating qualifies for £9,000 for installations from 21 July 2026 to 31 March 2027, and air-to-air systems for £2,500. The MCS-certified installer named in your quote applies for the grant and deducts it from the price.
What to budget for heat pump repairs in Camden
These are guide prices including VAT. The rate for your visit in Camden is confirmed before we book it, and any repair is priced in writing before parts are ordered.
| Repair | Guide price |
|---|---|
| Fault-finding visit and diagnosis | £100–£200 |
| Sensor or thermistor replacement | £130–£310 |
| Expansion vessel or pressure relief valve | £170–£390 |
| Circulating pump replacement | £280–£540 |
| Fan motor replacement | £340–£730 |
| Refrigerant leak repair and re-gas (split systems) | £390–£1,050 |
| Main control board (PCB) replacement | £500–£1,250 |
Inc VAT. The fault-finding rate is agreed before we attend; repairs are priced in writing before parts are ordered.
Short winter days in Camden and what they mean
On the shortest day Camden gets about 7 hours 49 minutes of daylight, and the winter sun reaches only around 15° above the horizon at noon. Winters this far south are milder than in most of the UK, which helps a heat pump run at low flow temperatures for much of the season.
How a visit works in Camden
- Tell us the make if you know it, the error code or symptoms, and send photos of the unit and controller.
- We confirm the fault-finding rate and arrange a visit in Camden.
- The engineer diagnoses the fault and gives you a written price for the repair.
- Parts are ordered once you agree, and the repair is completed and tested.
Heat pump repairs in Camden: questions
What should I check before booking a visit in Camden?
Note any error code on the controller, check the system pressure gauge if you have one, and make sure the outdoor unit is clear of leaves or snow. Photos of the unit and controller help.
Can you work on a heat pump in Camden that someone else installed?
Yes. We arrange servicing and repairs for most air source heat pumps in Camden, whoever fitted them. Tell us the make and model when you get in touch.
How much does a visit cost in Camden?
The rate for a service or fault-finding visit is agreed before anyone attends. Any repair is priced in writing before parts are ordered, so you decide before work goes ahead.
Do refrigerant repairs need a specialist?
Yes. Any work on a heat pump's refrigerant circuit, such as tracing a leak, replacing a component or re-gassing, must by law be done by an F-gas certified engineer where the refrigerant is fluorinated, such as R32; units using R290 (propane) need an engineer trained in flammable refrigerants. On split systems the refrigerant runs through pipes inside your home, so leaks there are more likely than on sealed monobloc units.
Can you repair a heat pump installed by another company?
Yes. We carry out fault-finding and repairs on heat pumps installed by other companies, including monobloc and split systems. Tell us the make, model and approximate age when you get in touch, plus any error code shown. If the system is still under the manufacturer's warranty, it may be quicker to contact the original installer or manufacturer first.