- Area
- Greater London
- Postcode district
- N8
- Nation
- England
- Guide price
- From £100 inc VAT
- Visit
- Rate agreed in advance
What to know about heat pump repairs in Crouch End
Aftercare matters as much as installation. For a heat pump in Crouch End the visit checks the outdoor unit, the water circuit and the controls, and the engineer explains any settings that would help the system run more efficiently.
Across Crouch End and Greater London, refrigerant repairs on split systems are carried out by an F-gas certified engineer. We repair heat pumps in Crouch End whoever installed them, including older monobloc and split systems.
When a heat pump shows an error, loses pressure or stops heating, an engineer diagnoses the cause and explains the repair and its cost before fixing it.
- Outdoor units that have become noisy, iced up or keep switching on and off
- Rooms or hot water not getting warm enough
- Heat pumps showing an error code or fault light
What's included
- Supply and fitting of replacement parts
- Fault-finding visit at a rate agreed before attending
- System refill, venting and recommissioning after the repair
- A clear explanation of the fault and a price for the repair before work goes ahead
- Reading of error history and operating data
Outdoor units in exposed spots around Crouch End can ice more heavily, so siting is checked as part of any icing fault.
Grants and rules for heat pumps in England
In England the Boiler Upgrade Scheme gives £7,500 towards an air source heat pump (£9,000 if it replaces oil or LPG, from 21 July 2026 to 31 March 2027), and since 28 April 2026 a valid EPC is no longer needed. The grant is applied for by the MCS-certified installer and shown as a deduction on your Crouch End quote.
Guide prices for heat pump repairs in Crouch End
Guide prices for Greater London, including VAT. We agree the visit rate before anyone attends, so there are no surprises on the day.
| Repair | Guide price |
|---|---|
| Fault-finding visit and diagnosis | £100–£200 |
| Sensor or thermistor replacement | £130–£310 |
| Expansion vessel or pressure relief valve | £170–£390 |
| Circulating pump replacement | £280–£540 |
| Fan motor replacement | £340–£730 |
| Refrigerant leak repair and re-gas (split systems) | £390–£1,050 |
| Main control board (PCB) replacement | £500–£1,250 |
Inc VAT. The fault-finding rate is agreed before we attend; repairs are priced in writing before parts are ordered.
Designing for Crouch End's winters
On the shortest day Crouch End gets about 7 hours 49 minutes of daylight, and the winter sun reaches only around 15° above the horizon at noon. Winters this far south are milder than in most of the UK, which helps a heat pump run at low flow temperatures for much of the season.
Booking a visit in Crouch End
- Tell us the make if you know it, the error code or symptoms, and send photos of the unit and controller.
- We confirm the fault-finding rate and arrange a visit in Crouch End.
- The engineer diagnoses the fault and gives you a written price for the repair.
- Parts are ordered once you agree, and the repair is completed and tested.
Heat pump repairs in Crouch End: questions
What should I check before booking a visit in Crouch End?
Note any error code on the controller, check the system pressure gauge if you have one, and make sure the outdoor unit is clear of leaves or snow. Photos of the unit and controller help.
How often should a heat pump in Crouch End be serviced?
Once a year is the usual recommendation, and many manufacturers make annual servicing a condition of the warranty. Check your warranty terms for the exact requirement.
Can you work on a heat pump in Crouch End that someone else installed?
Yes. We arrange servicing and repairs for most air source heat pumps in Crouch End, whoever fitted them. Tell us the make and model when you get in touch.
Can you repair a heat pump installed by another company?
Yes. We carry out fault-finding and repairs on heat pumps installed by other companies, including monobloc and split systems. Tell us the make, model and approximate age when you get in touch, plus any error code shown. If the system is still under the manufacturer's warranty, it may be quicker to contact the original installer or manufacturer first.
Is ice on my heat pump a fault?
Some frost on the outdoor unit in cold, damp weather is normal, and the unit clears it with regular defrost cycles, often releasing a little vapour. It becomes a fault when thick ice builds up and does not clear, or when ice blocks the fan. That can point to poor airflow, a failed sensor, drainage problems or low refrigerant, and needs checking.