- Area
- Greater Manchester
- Postcode district
- M2
- Nation
- England
- Guide price
- From £90 inc VAT
- Visit
- Rate agreed in advance
What to know about heat pump repairs in Manchester
Aftercare matters as much as installation. For a heat pump in Manchester the visit checks the outdoor unit, the water circuit and the controls, and the engineer explains any settings that would help the system run more efficiently.
Outdoor units in exposed spots around Manchester can ice more heavily, so siting is checked as part of any icing fault. We repair heat pumps in Manchester whoever installed them, including older monobloc and split systems.
When a heat pump shows an error, loses pressure or stops heating, an engineer diagnoses the cause and explains the repair and its cost before fixing it.
- Heat pumps showing an error code or fault light
- Outdoor units that have become noisy, iced up or keep switching on and off
- Rooms or hot water not getting warm enough
What's included
- Supply and fitting of replacement parts
- Fault-finding visit at a rate agreed before attending
- Reading of error history and operating data
- Refrigerant repairs by an F-gas certified engineer where needed
- A clear explanation of the fault and a price for the repair before work goes ahead
Across Manchester and Greater Manchester, refrigerant repairs on split systems are carried out by an F-gas certified engineer.
Grants and rules for heat pumps in England
In England the Boiler Upgrade Scheme gives £7,500 towards an air source heat pump (£9,000 if it replaces oil or LPG, from 21 July 2026 to 31 March 2027), and since 28 April 2026 a valid EPC is no longer needed. The grant is applied for by the MCS-certified installer and shown as a deduction on your Manchester quote.
Heat pump repairs costs around Manchester
Guide prices for Greater Manchester, including VAT. We agree the visit rate before anyone attends, so there are no surprises on the day.
| Repair | Guide price |
|---|---|
| Fault-finding visit and diagnosis | £90–£180 |
| Sensor or thermistor replacement | £120–£270 |
| Expansion vessel or pressure relief valve | £150–£340 |
| Circulating pump replacement | £240–£470 |
| Fan motor replacement | £290–£640 |
| Refrigerant leak repair and re-gas (split systems) | £340–£930 |
| Main control board (PCB) replacement | £440–£1,100 |
Inc VAT. The fault-finding rate is agreed before we attend; repairs are priced in writing before parts are ordered.
Winter daylight and heating in Manchester
Manchester sees roughly 7 hours 28 minutes of daylight in December and 17 hours 02 minutes in June. With a longer heating season than the south, the gains from low flow temperatures and good controls add up over the year.
Booking a visit in Manchester
- Tell us the make if you know it, the error code or symptoms, and send photos of the unit and controller.
- We confirm the fault-finding rate and arrange a visit in Manchester.
- The engineer diagnoses the fault and gives you a written price for the repair.
- Parts are ordered once you agree, and the repair is completed and tested.
Heat pump repairs in Manchester: questions
How often should a heat pump in Manchester be serviced?
Once a year is the usual recommendation, and many manufacturers make annual servicing a condition of the warranty. Check your warranty terms for the exact requirement.
What should I check before booking a visit in Manchester?
Note any error code on the controller, check the system pressure gauge if you have one, and make sure the outdoor unit is clear of leaves or snow. Photos of the unit and controller help.
Do you also cover Stretford?
Yes. We arrange heat pump servicing and repairs in Stretford, which is about 4 miles south-west of Manchester, and across Greater Manchester.
Is ice on my heat pump a fault?
Some frost on the outdoor unit in cold, damp weather is normal, and the unit clears it with regular defrost cycles, often releasing a little vapour. It becomes a fault when thick ice builds up and does not clear, or when ice blocks the fan. That can point to poor airflow, a failed sensor, drainage problems or low refrigerant, and needs checking.
Why does my heat pump keep switching on and off?
Frequent starting and stopping, called short cycling, is usually caused by an oversized heat pump, low water flow, too many zones closing at once or controls set with too narrow a range. It reduces efficiency and wears components. An engineer can check the settings, flow rates and design, and can often improve it with control changes before any parts are needed.