- Area
- Greater Manchester
- Postcode district
- WN7
- Nation
- England
- Guide price
- From £120 inc VAT
- Visit
- Rate agreed in advance
Heat pump servicing for Leigh homes
Aftercare matters as much as installation. For a heat pump in Leigh the visit checks the outdoor unit, the water circuit and the controls, and the engineer explains any settings that would help the system run more efficiently.
Heat pumps in Leigh that sit near trees or hedges often need their outdoor coil cleared of leaves at the annual service. Landlords in Leigh can arrange servicing for several properties, with a dated record for each.
An annual service keeps a heat pump running efficiently, catches small faults early and is often a condition of the manufacturer's warranty.
- Homes where running costs have crept up or rooms feel cooler than before
- Systems where the manufacturer's warranty requires annual servicing
- Heat pumps a year or more past installation
What's included
- Glycol or antifreeze protection test where fitted
- Unvented cylinder safety checks and legionella cycle check
- Refrigerant circuit checks on split systems by an F-gas certified engineer
- Cleaning of the outdoor unit coil, fan area and condensate drain
- Expansion vessel, pressure relief and water quality checks
Homes in Leigh and across Greater Manchester can book servicing at a time of year that suits them, ideally before winter.
Grants and rules for heat pumps in England
In England the Boiler Upgrade Scheme gives £7,500 towards an air source heat pump (£9,000 if it replaces oil or LPG, from 21 July 2026 to 31 March 2027), and since 28 April 2026 a valid EPC is no longer needed. The grant is applied for by the MCS-certified installer and shown as a deduction on your Leigh quote.
What to budget for heat pump servicing in Leigh
Guide prices for Greater Manchester, including VAT. We agree the visit rate before anyone attends, so there are no surprises on the day.
| Visit | Guide price |
|---|---|
| Annual heat pump service | £120–£240 |
| Fault-finding visit (first hour) | £90–£180 |
Inc VAT. The rate for your visit is confirmed before booking.
How long is the heating season in Leigh?
On the shortest day Leigh gets only about 7 hours 28 minutes of daylight and the noon sun sits around 13° above the horizon. Northern winters tend to be longer, so a well-designed, efficient system matters more here because it runs for more of the year.
What happens when you book in Leigh?
- Book a service and tell us roughly how old the system is.
- An engineer visits your Leigh home and works through the service checklist.
- You receive a written record of the service and any recommendations.
- If a repair is needed, it is priced in writing before any work goes ahead.
Heat pump servicing in Leigh: questions
Will the engineer need access indoors as well as outside?
Usually yes. The outdoor unit, the hot water cylinder, the controls and the pipework and valves indoors are all part of the visit, so allow access to each.
Do you also cover Atherton?
Yes. We arrange heat pump servicing and repairs in Atherton, which is about 2 miles north-east of Leigh, and across Greater Manchester.
What should I check before booking a visit in Leigh?
Note any error code on the controller, check the system pressure gauge if you have one, and make sure the outdoor unit is clear of leaves or snow. Photos of the unit and controller help.
How often should a heat pump be serviced?
Once a year is the usual recommendation for air source heat pumps, and many manufacturers require it as a warranty condition. An annual visit cleans filters and strainers, checks pressures and controls, and tests the unvented cylinder's safety devices. If you notice a drop in performance, unusual noises or repeated error codes between services, arrange a visit sooner.
Can you service a split system?
Yes. Split systems have refrigerant pipes running between the outdoor unit and an indoor unit, and checks on that refrigerant circuit must be done by an F-gas certified engineer. We arrange the service so a suitably certified engineer attends. The water side, controls and cylinder are checked in the same visit, just as on a monobloc system.