Wet underfloor heating is a network of plastic pipes laid under the floor that carries warm water from the heat pump and turns the whole floor into a large, low-temperature radiator. Because the heating surface is so big, it can keep a room comfortable with water at around 35–40°C, which is the range where heat pumps typically work most efficiently.
Kitchen extensions in Ayrshire are often the natural place to add underfloor heating when a heat pump goes in. Older houses around Ayrshire with suspended timber floors can often take underfloor pipes between the joists. We coordinate with builders working in Ayrshire so underfloor pipes are laid and tested before the screed goes down.
Who it suits
- Self-builds and new floors where insulation and screed are going in anyway
- Homeowners who want even, gentle warmth with no radiators on show
- Rooms where wall space for radiators is scarce
- Extensions, especially open-plan kitchen-diners with large glazed areas
Grants and rules for heat pumps in Scotland
The Boiler Upgrade Scheme does not apply in Scotland. Instead, homeowners in Ayrshire can apply to Home Energy Scotland for a grant of up to £7,500 towards a heat pump, with up to £1,500 more for eligible rural and island homes, plus an optional interest-free loan of up to £7,500. You need a written funding offer before any work starts.
There is no VAT on installing a heat pump anywhere in the UK, Scotland included, until 31 March 2027. Scottish permitted development rules and building standards apply, and the surveyor checks the unit position and any listed or conservation-area constraints.
Underfloor heating with heat pumps prices in Ayrshire
The ranges below are typical installed prices for homes in Ayrshire, including VAT. A survey sets the exact figure, because two similar-looking houses in Ayrshire can need quite different radiators and pipework.
| Work | Guide price |
|---|---|
| Wet underfloor heating, one room | £1,500–£3,500 |
| Wet underfloor heating, whole ground floor | £5,000–£15,000 |
Installed, inc VAT. Floor finishes and screed drying time are confirmed at survey.
Towns we cover in Ayrshire
We cover 11 towns in Ayrshire for underfloor heating with a heat pump. Each links to local guide prices and the grant position for Scotland.
| Town | Postcode district | Nearest town | Midwinter daylight |
|---|---|---|---|
| Kilmarnock | KA1 | Stewarton | 7 h 02 min |
| Ayr | KA8 | Prestwick | 7 h 04 min |
| Irvine | KA12 | Saltcoats | 7 h 02 min |
| Ardrossan | KA22 | Saltcoats | 7 h 01 min |
| Cumnock | KA18 | Prestwick | 7 h 04 min |
| Girvan | KA26 | Ayr | 7 h 07 min |
| Largs | KA30 | Ardrossan | 6 h 59 min |
| Prestwick | KA8 | Ayr | 7 h 04 min |
| Saltcoats | KA21 | Ardrossan | 7 h 02 min |
| Stewarton | KA3 | Kilmarnock | 7 h 01 min |
| Troon | KA10 | Prestwick | 7 h 03 min |
Underfloor heating with a heat pump questions
Is underfloor heating better than radiators with a heat pump?
Underfloor heating usually allows a lower flow temperature than radiators, which helps a heat pump run efficiently. That does not make radiators a poor choice: correctly sized radiators also work well, and they are far less disruptive to fit in existing rooms. Many homes use underfloor heating in an extension or on the ground floor and radiators elsewhere.
How much does underfloor heating cost with a heat pump?
Wet underfloor heating for a whole ground floor has a guide price of £5,000–£15,000, installed and including VAT, and a single room has a guide price of £1,500–£3,500. The spread reflects floor type, area, whether an overlay or screed system is used and how much floor preparation is needed. Your written quote fixes the price after the survey.
Can I heat just one room with underfloor heating?
Yes. A single room, such as a kitchen extension, can have its own underfloor zone connected to the heat pump alongside the radiators in the rest of the house. It needs its own thermostat and a manifold, which for one room can be compact. The design checks the room's heat loss so the floor can meet it at the system's flow temperature.
How long does a screed floor take before I can use the heating?
Screed needs to dry before the heating is used at full temperature and before most floor finishes are laid. Drying time depends on the screed type, depth and conditions, from around a week for some liquid screeds to several weeks or more for traditional sand and cement. The heating is then brought up gradually over several days to avoid cracking.