Air source heat pumps, surveyed, designed and installed· Free home survey for installation enquiries
0800 088 6341
Underfloor heating with heat pumps
England · 9 towns

Underfloor heating with heat pumps in the East Riding of Yorkshire

We arrange air source heat pumps for homes throughout the East Riding of Yorkshire, from the first heat loss survey to commissioning and annual servicing.

Underfloor heating can cover one room, an extension or the whole ground floor, and it works alongside radiators upstairs. We design it from the same room-by-room heat loss figures as the rest of the system, set out pipe spacing and zones for each room, and confirm which floor finishes will let the heat through.

Older houses around the East Riding of Yorkshire with suspended timber floors can often take underfloor pipes between the joists. Kitchen extensions in the East Riding of Yorkshire are often the natural place to add underfloor heating when a heat pump goes in. For homes in the East Riding of Yorkshire with solid ground floors, a low-profile overlay system can avoid breaking up the existing floor.

Who it suits

  • Homeowners who want even, gentle warmth with no radiators on show
  • Extensions, especially open-plan kitchen-diners with large glazed areas
  • Rooms where wall space for radiators is scarce
  • Ground floors being dug out or relaid as part of wider building work

Grants and rules for heat pumps in England

England

Homes in the East Riding of Yorkshire can use the Boiler Upgrade Scheme, which takes £7,500 off the cost of an air source heat pump when it replaces fossil-fuel or electric heating. Replacing oil or LPG heating qualifies for £9,000 for installations from 21 July 2026 to 31 March 2027, and air-to-air systems for £2,500. The MCS-certified installer named in your quote applies for the grant and deducts it from the price.

Installing heat pumps is zero-rated for VAT across the UK until 31 March 2027. Since 29 May 2025, permitted development in England allows up to two air source heat pumps on a house, each up to 1.5 m³, with no blanket 1 m boundary rule — the installation must still meet the MCS planning standards, including the noise check. Listed buildings, flats and some conservation-area positions need extra consent, which we check at survey.

Underfloor heating with heat pumps prices in the East Riding of Yorkshire

The ranges below are typical installed prices for homes in the East Riding of Yorkshire, including VAT. A survey sets the exact figure, because two similar-looking houses in the East Riding of Yorkshire can need quite different radiators and pipework.

Underfloor heating with heat pumps prices in the East Riding of Yorkshire
WorkGuide price
Wet underfloor heating, one room£1,450–£3,450
Wet underfloor heating, whole ground floor£4,900–£14,700

Installed, inc VAT. Floor finishes and screed drying time are confirmed at survey.

Towns we cover in the East Riding of Yorkshire

We cover 9 towns in the East Riding of Yorkshire for underfloor heating with a heat pump. Each links to local guide prices and the grant position for England.

TownPostcode districtNearest townMidwinter daylight
HullHU1Beverley7 h 25 min
BridlingtonYO16Driffield7 h 21 min
BeverleyHU17Hull7 h 24 min
GooleDN14Howden7 h 26 min
BroughHU15Hull7 h 25 min
DriffieldYO25Beverley7 h 22 min
HornseaHU18Beverley7 h 23 min
HowdenDN14Goole7 h 25 min
PocklingtonYO42Howden7 h 23 min

Underfloor heating with a heat pump questions

How much does underfloor heating cost with a heat pump?

Wet underfloor heating for a whole ground floor has a guide price of £5,000–£15,000, installed and including VAT, and a single room has a guide price of £1,500–£3,500. The spread reflects floor type, area, whether an overlay or screed system is used and how much floor preparation is needed. Your written quote fixes the price after the survey.

Can I heat just one room with underfloor heating?

Yes. A single room, such as a kitchen extension, can have its own underfloor zone connected to the heat pump alongside the radiators in the rest of the house. It needs its own thermostat and a manifold, which for one room can be compact. The design checks the room's heat loss so the floor can meet it at the system's flow temperature.

How long does a screed floor take before I can use the heating?

Screed needs to dry before the heating is used at full temperature and before most floor finishes are laid. Drying time depends on the screed type, depth and conditions, from around a week for some liquid screeds to several weeks or more for traditional sand and cement. The heating is then brought up gradually over several days to avoid cracking.

Is underfloor heating better than radiators with a heat pump?

Underfloor heating usually allows a lower flow temperature than radiators, which helps a heat pump run efficiently. That does not make radiators a poor choice: correctly sized radiators also work well, and they are far less disruptive to fit in existing rooms. Many homes use underfloor heating in an extension or on the ground floor and radiators elsewhere.

Ready to price your heat pump?

Use the guide price tool, or book a free home survey and fixed written quote.

CallGet a quote