- Area
- Greater London
- Postcode district
- IG1
- Nation
- England
- Guide price
- From £10,650 inc VAT
- Survey
- Free for installation enquiries
Before you book: air source heat pump installation in Ilford
Homes around Ilford range from older terraces to newer estates, and each needs a different design. That is why we survey before we quote.
For older properties in Ilford, the heat loss calculation looks closely at solid walls, single glazing and draughts before any unit is sized. Terraced streets in Ilford often mean a compact unit position at the rear, so siting and sound levels are checked carefully.
We survey your home, design a heat pump system around its real heat loss, and manage the installation from the first visit to the MCS certificate.
- Owners and landlords in England and Wales eligible for the Boiler Upgrade Scheme
- Houses with reasonable insulation, or a plan to improve it
- Homes replacing a gas, oil, LPG or electric heating system
What's included
- Radiator and pipework changes where the design needs them
- Boiler Upgrade Scheme application in England and Wales where eligible
- Outdoor unit, hot water cylinder and weather compensation controls
- Commissioning, handover and a walk-through of the controls
- Free home survey and room-by-room heat loss calculation
Installers working in Ilford plan the order of work so heating and hot water are off for as short a time as practical.
Grants and rules for heat pumps in England
In England the Boiler Upgrade Scheme gives £7,500 towards an air source heat pump (£9,000 if it replaces oil or LPG, from 21 July 2026 to 31 March 2027), and since 28 April 2026 a valid EPC is no longer needed. The grant is applied for by the MCS-certified installer and shown as a deduction on your Ilford quote.
Installing heat pumps is zero-rated for VAT across the UK until 31 March 2027. Since 29 May 2025, permitted development in England allows up to two air source heat pumps on a house, each up to 1.5 m³, with no blanket 1 m boundary rule — the installation must still meet the MCS planning standards, including the noise check. Listed buildings, flats and some conservation-area positions need extra consent, which we check at survey.
Air source heat pump installation prices in Ilford
The ranges below are typical installed prices for homes in Greater London, including VAT. A survey sets the exact figure, because two similar-looking houses in Ilford can need quite different radiators and pipework.
| Home | Typical size | Installed guide price | After £7,500 grant |
|---|---|---|---|
| 1–2 bedroom flat or small terrace | 4–5 kW | £10,650–£14,000 | £3,150–£6,500 |
| 2–3 bedroom terrace or semi | 5–7 kW | £11,750–£15,100 | £4,250–£7,600 |
| 3 bedroom semi or small detached | 6–9 kW | £13,450–£17,350 | £5,950–£9,850 |
| 4 bedroom detached | 8–12 kW | £15,700–£20,150 | £8,200–£12,650 |
| 5+ bedroom or larger older house | 11–16 kW | £18,500–£25,200 | £11,000–£17,700 |
Installed, inc VAT: unit, cylinder, controls, minor pipework and commissioning.
Short winter days in Ilford and what they mean
Ilford sees roughly 7 hours 49 minutes of daylight in late December against 16 hours 39 minutes in June. Milder southern winters suit heat pumps well, though the system is still sized for a cold snap rather than an average day.
How installation works in Ilford
- Send your postcode and a few details, or use the guide price tool.
- A surveyor visits your Ilford home, measures every room and checks where the outdoor unit can go.
- You receive a heat loss design and a fixed written quote, with any grant shown where it applies.
- Installers fit the unit, cylinder and any radiator changes, typically over 2–4 days on site.
- The system is commissioned, set up with weather compensation and handed over with the paperwork.
Air source heat pump installation in Ilford: questions
What size heat pump does an Ilford home need?
It depends on the heat loss, not the postcode. As a rough guide, a 3 bedroom semi often needs 6–9 kW, but the room-by-room survey sets the actual size for your Ilford home.
How soon can you survey a home in Ilford?
Survey dates depend on how busy installers are in Greater London. We offer the next available dates when you enquire and confirm them in writing.
Do I need new radiators for a heat pump in Ilford?
Often some, not all. Heat pumps run best at lower water temperatures, so rooms with small radiators may need larger ones. The survey of your Ilford home gives a room-by-room list.
Do I need new radiators for a heat pump?
Not always; many homes keep most of their radiators and change only a few. Because a heat pump runs at a lower water temperature than a boiler, each radiator gives out less heat, so the survey checks every room against its heat loss. Rooms where the existing radiator falls short get a larger one, with a guide price of £250–£450 each, installed and including VAT.
How long does an air source heat pump installation take?
A typical home installation takes 2–4 days on site. It takes longer if several radiators are being replaced, pipework is being upgraded or the cylinder is going in a new location. Your quote sets out the expected programme, including when you will be without heating and hot water. Timings are typical rather than fixed, because older homes sometimes reveal surprises once floorboards are lifted.