- Area
- Greater London
- Postcode district
- SW2
- Nation
- England
- Guide price
- From £2,700 inc VAT
- Survey
- Free for installation enquiries
Before you book: air-to-air heat pumps in Brixton
Every property in Brixton is different, so the design starts from measurements rather than a rule of thumb. That keeps the system the right size and the running costs predictable.
A survey in Brixton covers indoor unit positions, pipe routes and hot water for homes across Greater London. Flats in Brixton on storage or panel heaters can often switch to air-to-air without fitting radiators or pipework.
An air-to-air heat pump warms rooms directly with air, and can cool them in summer, but it does not heat your hot water.
- Households that already have, or will add, a separate source of hot water
- Homes where fitting radiators and pipework would be very disruptive
- Flats and apartments with storage or panel heaters
What's included
- Commissioning, MCS certificate and the air-to-air grant claim in England and Wales where eligible
- Free survey covering rooms to heat, unit positions and hot water options
- Electrical supply and controls set up for each room
- Refrigerant pipe runs to each indoor unit, made and charged by an F-gas certified engineer
- Condensate drains and neat external pipe covers
Top-floor rooms in Brixton that overheat in summer gain from the cooling an air-to-air system provides.
Grants and rules for heat pumps in England
Homes in Brixton can use the Boiler Upgrade Scheme, which takes £7,500 off the cost of an air source heat pump when it replaces fossil-fuel or electric heating. Replacing oil or LPG heating qualifies for £9,000 for installations from 21 July 2026 to 31 March 2027, and air-to-air systems for £2,500. The MCS-certified installer named in your quote applies for the grant and deducts it from the price.
There is no VAT on installing a heat pump anywhere in the UK until 31 March 2027. In England most houses can have an air source heat pump under permitted development, provided the unit meets the MCS noise and siting standards; the old 1 m boundary limit was removed on 29 May 2025. We flag listed buildings, flats and sensitive conservation-area positions at survey.
Air-to-air heat pumps prices in Brixton
The ranges below are typical installed prices for homes in Greater London, including VAT. A survey sets the exact figure, because two similar-looking houses in Brixton can need quite different radiators and pipework.
| System | Installed guide price |
|---|---|
| Air-to-air heat pump, 1–2 rooms | £2,700–£5,600 |
| Air-to-air heat pump, multi-room 3–4 bedroom home | £4,500–£8,950 |
Installed, inc VAT. Air-to-air systems heat (and can cool) rooms but do not provide hot water. In England and Wales the Boiler Upgrade Scheme gives £2,500 towards an air-to-air system in a home, deducted from your quote where eligible.
Short winter days in Brixton and what they mean
On the shortest day Brixton gets about 7 hours 50 minutes of daylight, and the winter sun reaches only around 15° above the horizon at noon. Winters this far south are milder than in most of the UK, which helps a heat pump run at low flow temperatures for much of the season.
How installation works in Brixton
- Send your postcode and a few details, or use the guide price tool.
- A surveyor visits your Brixton home, measures every room and checks where the outdoor unit can go.
- You receive a heat loss design and a fixed written quote, with any grant shown where it applies.
- Installers fit the unit, cylinder and any radiator changes, typically over 2–4 days on site.
- The system is commissioned, set up with weather compensation and handed over with the paperwork.
Air-to-air heat pumps in Brixton: questions
Do you cover Clapham as well as Brixton?
Yes. We arrange surveys and installation in Clapham, which is about a mile west of Brixton, and across Greater London.
Where would the outdoor unit go on a Brixton house?
Usually at the side or rear, on a level base with space around it for airflow and servicing, away from bedroom windows where possible. The surveyor checks positions at your Brixton home.
How long does a heat pump survey take in Brixton?
A home survey in Brixton usually takes one to two hours. The surveyor measures every heated room, checks windows, walls and radiators, and looks at where the outdoor unit and cylinder can go.
How much sound do the indoor units make?
Indoor units are designed to run quietly, with a fan you will hear most when heating or cooling at full output. Lower fan settings and night modes reduce sound in bedrooms. Siting matters for the outdoor unit too: it needs airflow and a position that passes the MCS noise assessment. Ask to see the sound levels of the proposed units at survey.
Are air-to-air heat pumps suitable for flats?
Often, yes. They need no radiators, pipework or cylinder, so they suit flats heated by storage or panel heaters. You need a position for the outdoor unit, such as a balcony, wall bracket or ground-floor yard, and leaseholders normally need the freeholder's or management company's consent. Planning rules for flats differ by nation, so we check what applies at survey.