- Area
- Kent
- Postcode district
- ME1
- Nation
- England
- Guide price
- From £2,450 inc VAT
- Survey
- Free for installation enquiries
Before you book: air-to-air heat pumps in Rochester
Every property in Rochester is different, so the design starts from measurements rather than a rule of thumb. That keeps the system the right size and the running costs predictable.
Flats in Rochester on storage or panel heaters can often switch to air-to-air without fitting radiators or pipework. For terraced homes in Rochester, the outdoor unit can often sit in a rear yard with tidy pipe runs to each room.
An air-to-air heat pump warms rooms directly with air, and can cool them in summer, but it does not heat your hot water.
- Rooms that get too hot in summer as well as cold in winter
- Homes where fitting radiators and pipework would be very disruptive
- Households that already have, or will add, a separate source of hot water
What's included
- Electrical supply and controls set up for each room
- Commissioning, MCS certificate and the air-to-air grant claim in England and Wales where eligible
- Outdoor unit and indoor units for each room
- Refrigerant pipe runs to each indoor unit, made and charged by an F-gas certified engineer
- Condensate drains and neat external pipe covers
Extensions and garden rooms in Rochester that are hard to connect to the main heating can have their own air-to-air unit.
Grants and rules for heat pumps in England
In England the Boiler Upgrade Scheme gives £7,500 towards an air source heat pump (£9,000 if it replaces oil or LPG, from 21 July 2026 to 31 March 2027), and since 28 April 2026 a valid EPC is no longer needed. The grant is applied for by the MCS-certified installer and shown as a deduction on your Rochester quote.
There is no VAT on installing a heat pump anywhere in the UK until 31 March 2027. In England most houses can have an air source heat pump under permitted development, provided the unit meets the MCS noise and siting standards; the old 1 m boundary limit was removed on 29 May 2025. We flag listed buildings, flats and sensitive conservation-area positions at survey.
Air-to-air heat pumps prices in Rochester
The ranges below are typical installed prices for homes in Kent, including VAT. A survey sets the exact figure, because two similar-looking houses in Rochester can need quite different radiators and pipework.
| System | Installed guide price |
|---|---|
| Air-to-air heat pump, 1–2 rooms | £2,450–£5,150 |
| Air-to-air heat pump, multi-room 3–4 bedroom home | £4,100–£8,250 |
Installed, inc VAT. Air-to-air systems heat (and can cool) rooms but do not provide hot water. In England and Wales the Boiler Upgrade Scheme gives £2,500 towards an air-to-air system in a home, deducted from your quote where eligible.
Short winter days in Rochester and what they mean
On the shortest day Rochester gets about 7 hours 51 minutes of daylight, and the winter sun reaches only around 15° above the horizon at noon. Winters this far south are milder than in most of the UK, which helps a heat pump run at low flow temperatures for much of the season.
How installation works in Rochester
- Send your postcode and a few details, or use the guide price tool.
- A surveyor visits your Rochester home, measures every room and checks where the outdoor unit can go.
- You receive a heat loss design and a fixed written quote, with any grant shown where it applies.
- Installers fit the unit, cylinder and any radiator changes, typically over 2–4 days on site.
- The system is commissioned, set up with weather compensation and handed over with the paperwork.
Air-to-air heat pumps in Rochester: questions
How long does installation take in Rochester?
Most installations take 2–4 days on site. Jobs with several radiator changes or new pipework take longer, and your quote for a Rochester home states the expected time.
How soon can you survey a home in Rochester?
Survey dates depend on how busy installers are in Kent. We offer the next available dates when you enquire and confirm them in writing.
Where would the outdoor unit go on a Rochester house?
Usually at the side or rear, on a level base with space around it for airflow and servicing, away from bedroom windows where possible. The surveyor checks positions at your Rochester home.
Can an air-to-air heat pump heat my water?
No. An air-to-air heat pump heats and cools the air in rooms but does not produce hot water. You need a separate source, such as an existing immersion cylinder, a hot water heat pump or an electric water heater. If you want one system for heating and hot water, an air-to-water heat pump with a cylinder is the alternative.
Are air-to-air heat pumps suitable for flats?
Often, yes. They need no radiators, pipework or cylinder, so they suit flats heated by storage or panel heaters. You need a position for the outdoor unit, such as a balcony, wall bracket or ground-floor yard, and leaseholders normally need the freeholder's or management company's consent. Planning rules for flats differ by nation, so we check what applies at survey.