- Area
- Kent
- Postcode district
- CT5
- Nation
- England
- Guide price
- From £2,450 inc VAT
- Survey
- Free for installation enquiries
Before you book: air-to-air heat pumps in Whitstable
In Whitstable, as anywhere in the UK, the heat pumps that perform well are the ones designed around low flow temperatures and sized from a proper heat loss calculation.
A survey in Whitstable covers indoor unit positions, pipe routes and hot water for homes across Kent. Installers in Whitstable plan condensate drains and pipe covers so indoor and outdoor runs stay neat.
An air-to-air heat pump warms rooms directly with air, and can cool them in summer, but it does not heat your hot water.
- Extensions, conservatories and garden rooms
- Rooms that get too hot in summer as well as cold in winter
- Households that already have, or will add, a separate source of hot water
What's included
- Refrigerant pipe runs to each indoor unit, made and charged by an F-gas certified engineer
- Free survey covering rooms to heat, unit positions and hot water options
- Electrical supply and controls set up for each room
- Outdoor unit and indoor units for each room
- Condensate drains and neat external pipe covers
For terraced homes in Whitstable, the outdoor unit can often sit in a rear yard with tidy pipe runs to each room.
Grants and rules for heat pumps in England
Homes in Whitstable can use the Boiler Upgrade Scheme, which takes £7,500 off the cost of an air source heat pump when it replaces fossil-fuel or electric heating. Replacing oil or LPG heating qualifies for £9,000 for installations from 21 July 2026 to 31 March 2027, and air-to-air systems for £2,500. The MCS-certified installer named in your quote applies for the grant and deducts it from the price.
There is no VAT on installing a heat pump anywhere in the UK until 31 March 2027. In England most houses can have an air source heat pump under permitted development, provided the unit meets the MCS noise and siting standards; the old 1 m boundary limit was removed on 29 May 2025. We flag listed buildings, flats and sensitive conservation-area positions at survey.
Guide prices for air-to-air heat pumps in Whitstable
Here are typical prices for air-to-air heat pumps in Kent, installed and including VAT. Use the guide price tool for a figure based on your home, then a survey confirms it in writing.
| System | Installed guide price |
|---|---|
| Air-to-air heat pump, 1–2 rooms | £2,450–£5,150 |
| Air-to-air heat pump, multi-room 3–4 bedroom home | £4,100–£8,250 |
Installed, inc VAT. Air-to-air systems heat (and can cool) rooms but do not provide hot water. In England and Wales the Boiler Upgrade Scheme gives £2,500 towards an air-to-air system in a home, deducted from your quote where eligible.
Winter daylight and heating in Whitstable
On the shortest day Whitstable gets about 7 hours 51 minutes of daylight, and the winter sun reaches only around 15° above the horizon at noon. Winters this far south are milder than in most of the UK, which helps a heat pump run at low flow temperatures for much of the season.
How installation works in Whitstable
- Start online with a guide price or call us.
- A home survey in Whitstable gives us the room-by-room heat loss.
- Your written quote sets out the design, the price and the grant position where you live.
- Installation is booked for dates that suit you; most homes take 2–4 days on site.
- After commissioning you get a handover of the controls and settings, plus the certificates.
Air-to-air heat pumps in Whitstable: questions
Do I need new radiators for a heat pump in Whitstable?
Often some, not all. Heat pumps run best at lower water temperatures, so rooms with small radiators may need larger ones. The survey of your Whitstable home gives a room-by-room list.
Do you cover Herne Bay as well as Whitstable?
Yes. We arrange surveys and installation in Herne Bay, which is about 5 miles east of Whitstable, and across Kent.
How long does installation take in Whitstable?
Most installations take 2–4 days on site. Jobs with several radiator changes or new pipework take longer, and your quote for a Whitstable home states the expected time.
How do I look after an air-to-air system?
Clean the indoor unit filters regularly, typically every few weeks during heavy use and following the manufacturer's guidance, and keep the outdoor unit clear of leaves and snow. Annual servicing is recommended and is often a condition of the manufacturer's warranty. Any work on the refrigerant circuit must be done by an F-gas certified engineer.
Can an air-to-air heat pump heat my water?
No. An air-to-air heat pump heats and cools the air in rooms but does not produce hot water. You need a separate source, such as an existing immersion cylinder, a hot water heat pump or an electric water heater. If you want one system for heating and hot water, an air-to-water heat pump with a cylinder is the alternative.