Replacing electric heating with a heat pump means taking out storage heaters, panel heaters or an electric boiler and installing an air-to-water heat pump that heats water for radiators or underfloor heating and a hot water cylinder. If you already have an electric boiler and radiators, the change is similar to a boiler swap. If you have storage or panel heaters, there is no wet system yet, so radiators and pipework need to be installed throughout.
Flats in Perth and Kinross heated by storage heaters can often switch, subject to the freeholder's consent and a workable outdoor position. Where a home in Perth and Kinross has an airing cupboard, the immersion cylinder can often be swapped for a heat pump cylinder in the same space. Bungalows around Perth and Kinross with suspended timber floors usually make running new pipework simpler.
Who it suits
- Owners planning redecoration or other building work at the same time
- Flats with a suitable wall, balcony or ground-floor space for the unit
- Properties with an electric boiler and existing radiators
- Bungalows and houses with suspended timber floors that make pipe runs easier
Grants and rules for heat pumps in Scotland
The Boiler Upgrade Scheme does not apply in Scotland. Instead, homeowners in Perth and Kinross can apply to Home Energy Scotland for a grant of up to £7,500 towards a heat pump, with up to £1,500 more for eligible rural and island homes, plus an optional interest-free loan of up to £7,500. You need a written funding offer before any work starts.
Installing heat pumps is zero-rated for VAT across the UK until 31 March 2027. Scotland has its own permitted development rules for air source heat pumps and its own building standards, so we confirm what applies to your property at survey.
Electric heating to heat pump prices in Perth and Kinross
Here are typical prices for replacing electric heating with a heat pump in Perth and Kinross, installed and including VAT. Use the guide price tool for a figure based on your home, then a survey confirms it in writing.
| Home | Typical size | Installed guide price |
|---|---|---|
| 1–2 bedroom flat or small terrace | 4–5 kW | £9,600–£12,650 |
| 2–3 bedroom terrace or semi | 5–7 kW | £10,600–£13,650 |
| 3 bedroom semi or small detached | 6–9 kW | £12,100–£15,650 |
| 4 bedroom detached | 8–12 kW | £14,150–£18,200 |
| 5+ bedroom or larger older house | 11–16 kW | £16,650–£22,750 |
Installed, inc VAT: unit, cylinder, controls, minor pipework and commissioning. In Scotland, Home Energy Scotland grants of up to £7,500 and interest-free loans may reduce the cost.
Towns we cover in Perth and Kinross
We cover 7 towns in Perth and Kinross for replacing electric heating with a heat pump. Each links to local guide prices and the grant position for Scotland.
| Town | Postcode district | Nearest town | Midwinter daylight |
|---|---|---|---|
| Perth | PH2 | Auchterarder | 6 h 51 min |
| Aberfeldy | PH15 | Pitlochry | 6 h 48 min |
| Auchterarder | PH3 | Crieff | 6 h 53 min |
| Blairgowrie | PH10 | Perth | 6 h 48 min |
| Crieff | PH7 | Auchterarder | 6 h 52 min |
| Kinross | KY13 | Dunfermline | 6 h 54 min |
| Pitlochry | PH16 | Aberfeldy | 6 h 47 min |
Replacing electric heating with a heat pump questions
How disruptive is fitting radiators in a home that has none?
More disruptive than a boiler swap, but planned. Floorboards are lifted to run pipes, some holes are drilled through walls and radiators are hung room by room. Rooms are worked on in a set order so you can keep living at home, and holes are made good, while redecoration is usually yours. The programme in your quote shows how long each stage typically takes.
What if I live in a flat?
Many flats can have a heat pump, but you need a suitable outdoor position, such as a balcony, yard or wall bracket, and leaseholders need consent from the freeholder or management company. Planning permission may be needed depending on the nation and the building, which we check at survey. Where a wet system is impractical, an air-to-air heat pump with separate hot water is an alternative.
Can I keep my electric immersion cylinder?
Usually not for heating by the heat pump, because a standard immersion cylinder has no coil, or one too small to take heat at low flow temperatures. A heat pump cylinder replaces it, often in the same cupboard, and keeps an immersion element as backup. If you choose an air-to-air system instead, which does not make hot water, the existing cylinder stays in use.
Is a heat pump cheaper to run than storage heaters?
It can be, but it depends on your tariff. Direct electric heat costs the full unit rate, 26.32p per kWh at the October to December 2026 price cap, while a heat pump with a seasonal efficiency of 3.0 delivers heat for about 8.8p per kWh. Storage heaters charged on a cheap overnight rate narrow that gap, so the survey compares on your actual tariff, insulation and expected flow temperature.