- Area
- East Sussex
- Postcode district
- BN25
- Nation
- England
- Guide price
- From £9,800 inc VAT
- Survey
- Free for installation enquiries
Gas boiler to heat pump for Seaford homes
In Seaford, as anywhere in the UK, the heat pumps that perform well are the ones designed around low flow temperatures and sized from a proper heat loss calculation.
Rear gardens and side returns in Seaford usually offer a sensible spot for the outdoor unit, checked for airflow and neighbours. Households across East Sussex moving off gas can have a survey in Seaford that compares running costs on realistic assumptions.
Moving from mains gas to a heat pump means finding cylinder space, deciding what happens to the gas supply and comparing running costs on realistic assumptions.
- Combi owners who can find space for a hot water cylinder
- Households ready to give up gas entirely and drop the standing charge
- Boilers that are old, unreliable or due for replacement
What's included
- Heat pump cylinder, outdoor unit and weather compensation controls
- Capping of the gas pipe at the boiler position where you are giving up gas
- Free survey with heat loss calculation and cylinder siting
- Commissioning, MCS certificate and grant application in England and Wales where eligible
- System flush and radiator upgrades where the design calls for them
If your Seaford home still cooks on gas, we talk through whether to keep the supply or switch to an induction hob.
Grants and rules for heat pumps in England
Homes in Seaford can use the Boiler Upgrade Scheme, which takes £7,500 off the cost of an air source heat pump when it replaces fossil-fuel or electric heating. Replacing oil or LPG heating qualifies for £9,000 for installations from 21 July 2026 to 31 March 2027, and air-to-air systems for £2,500. The MCS-certified installer named in your quote applies for the grant and deducts it from the price.
Installing heat pumps is zero-rated for VAT across the UK until 31 March 2027. Since 29 May 2025, permitted development in England allows up to two air source heat pumps on a house, each up to 1.5 m³, with no blanket 1 m boundary rule — the installation must still meet the MCS planning standards, including the noise check. Listed buildings, flats and some conservation-area positions need extra consent, which we check at survey.
Gas boiler to heat pump costs around Seaford
Here are typical prices for replacing a gas boiler with a heat pump in East Sussex, installed and including VAT. Use the guide price tool for a figure based on your home, then a survey confirms it in writing.
| Home | Typical size | Installed guide price | After £7,500 grant |
|---|---|---|---|
| 1–2 bedroom flat or small terrace | 4–5 kW | £9,800–£12,900 | £2,300–£5,400 |
| 2–3 bedroom terrace or semi | 5–7 kW | £10,800–£13,900 | £3,300–£6,400 |
| 3 bedroom semi or small detached | 6–9 kW | £12,350–£15,950 | £4,850–£8,450 |
| 4 bedroom detached | 8–12 kW | £14,400–£18,550 | £6,900–£11,050 |
| 5+ bedroom or larger older house | 11–16 kW | £17,000–£23,200 | £9,500–£15,700 |
Installed, inc VAT: unit, cylinder, controls, minor pipework and commissioning.
How long is the heating season in Seaford?
On the shortest day Seaford gets about 7 hours 57 minutes of daylight, and the winter sun reaches only around 16° above the horizon at noon. Winters this far south are milder than in most of the UK, which helps a heat pump run at low flow temperatures for much of the season.
From survey to switch-on in Seaford
- Send your postcode and a few details, or use the guide price tool.
- A surveyor visits your Seaford home, measures every room and checks where the outdoor unit can go.
- You receive a heat loss design and a fixed written quote, with any grant shown where it applies.
- Installers fit the unit, cylinder and any radiator changes, typically over 2–4 days on site.
- The system is commissioned, set up with weather compensation and handed over with the paperwork.
Replacing a gas boiler with a heat pump in Seaford: questions
What size heat pump does a Seaford home need?
It depends on the heat loss, not the postcode. As a rough guide, a 3 bedroom semi often needs 6–9 kW, but the room-by-room survey sets the actual size for your Seaford home.
How long does installation take in Seaford?
Most installations take 2–4 days on site. Jobs with several radiator changes or new pipework take longer, and your quote for a Seaford home states the expected time.
Do I need new radiators for a heat pump in Seaford?
Often some, not all. Heat pumps run best at lower water temperatures, so rooms with small radiators may need larger ones. The survey of your Seaford home gives a room-by-room list.
Should I have my gas meter removed?
If gas is used for nothing else, removing the meter ends the gas standing charge, which is about £108 a year at the October to December 2026 price cap. If you still cook on gas or have a gas fire, you will need to keep the supply. Meter removal is arranged through your gas supplier, usually once the heat pump is running; the pipe at the boiler position is capped during the installation.
Do I need to replace the cylinder I already have?
Usually, yes. Older cylinders have a small internal coil designed for water from a boiler at around 60–70°C, and they cannot take in heat quickly enough at the lower temperatures a heat pump runs at. A heat pump cylinder has a larger coil. On its own, a cylinder supplied and fitted has a guide price of £1,200–£2,200, installed and including VAT, though it is normally part of the full system price.