- Area
- Lincolnshire
- Postcode district
- PE9
- Nation
- England
- Guide price
- Priced after survey
- Survey
- Free for installation enquiries
Before you book: heat loss surveys in Stamford
A heat pump suits most Stamford homes, but the details decide how efficiently it runs. Our survey looks at insulation, radiators and hot water use room by room.
Design outdoor temperatures for Stamford and the wider Lincolnshire come from local cold-weather data, not a national average. A surveyor visits your Stamford home to measure each room, window and wall before any heat pump is sized.
Every heat pump we quote starts with a room-by-room heat loss survey, free with installation enquiries and also available as a stand-alone report.
- Landlords comparing properties before deciding where to switch first
- Self-builders and architects who need emitter and system sizes early
- Homes with an existing heat pump that seems undersized or expensive to run
What's included
- Hot water cylinder sizing for your household
- Electrical supply and network operator notes
- Written results in your quote, or a stand-alone report if you order one
- Radiator schedule with any upgrades needed for each room
- Recommended heat pump size and design flow temperature
Houses in Stamford built in different eras can need very different heat pump sizes, which is why each is calculated room by room.
Grants and rules for heat pumps in England
Homes in Stamford can use the Boiler Upgrade Scheme, which takes £7,500 off the cost of an air source heat pump when it replaces fossil-fuel or electric heating. Replacing oil or LPG heating qualifies for £9,000 for installations from 21 July 2026 to 31 March 2027, and air-to-air systems for £2,500. The MCS-certified installer named in your quote applies for the grant and deducts it from the price.
Installing heat pumps is zero-rated for VAT across the UK until 31 March 2027. Since 29 May 2025, permitted development in England allows up to two air source heat pumps on a house, each up to 1.5 m³, with no blanket 1 m boundary rule — the installation must still meet the MCS planning standards, including the noise check. Listed buildings, flats and some conservation-area positions need extra consent, which we check at survey.
Heat loss survey prices in Stamford
Here are typical prices for heat loss surveys in Lincolnshire, installed and including VAT. Use the guide price tool for a figure based on your home, then a survey confirms it in writing.
| Survey | Guide price |
|---|---|
| Home survey and heat loss calculation with an installation quote | Free |
| Stand-alone heat loss survey and report | £150–£400 |
Inc VAT. A stand-alone report is for homeowners who want the design without an installation quote.
Designing for Stamford's winters
On the shortest day Stamford gets about 7 hours 37 minutes of daylight, with the noon sun around 14° up. The heating season runs from autumn into spring, so a heat pump that is sized correctly and set up with weather compensation does most of its work in steady, cool conditions.
The steps for heat loss surveys in Stamford
- Send your postcode and a few details, or use the guide price tool.
- A surveyor visits your Stamford home, measures every room and checks where the outdoor unit can go.
- You receive a heat loss design and a fixed written quote, with any grant shown where it applies.
- Installers fit the unit, cylinder and any radiator changes, typically over 2–4 days on site.
- The system is commissioned, set up with weather compensation and handed over with the paperwork.
Heat loss surveys in Stamford: questions
Do you cover Bourne as well as Stamford?
Yes. We arrange surveys and installation in Bourne, which is about 9 miles north-east of Stamford, and across Lincolnshire.
Do I need new radiators for a heat pump in Stamford?
Often some, not all. Heat pumps run best at lower water temperatures, so rooms with small radiators may need larger ones. The survey of your Stamford home gives a room-by-room list.
How long does a heat pump survey take in Stamford?
A home survey in Stamford usually takes one to two hours. The surveyor measures every heated room, checks windows, walls and radiators, and looks at where the outdoor unit and cylinder can go.
Why can't you size the heat pump from my boiler?
Boilers are often much larger than a home's real heat loss, because they are sized for fast hot water and quick warm-ups. Matching a heat pump to the boiler's output usually means an oversized unit that costs more and switches on and off too often. A room-by-room calculation finds the actual heat demand, which is what the heat pump needs to meet.
Is the heat loss survey free?
Yes, for installation enquiries the home survey and heat loss calculation are free, and the results form the basis of your written quote. If you only want the calculation and report, for example for building plans or comparing quotes, a stand-alone heat loss survey has a guide price of £150–£400, including VAT. We confirm which applies when you book.