- Area
- County Armagh
- Postcode district
- BT60
- Nation
- Northern Ireland
- Guide price
- From £90 inc VAT
- Visit
- Rate agreed in advance
Before you book: heat pump repairs in Keady
Aftercare matters as much as installation. For a heat pump in Keady the visit checks the outdoor unit, the water circuit and the controls, and the engineer explains any settings that would help the system run more efficiently.
Outdoor units in exposed spots around Keady can ice more heavily, so siting is checked as part of any icing fault. Across Keady and County Armagh, refrigerant repairs on split systems are carried out by an F-gas certified engineer.
When a heat pump shows an error, loses pressure or stops heating, an engineer diagnoses the cause and explains the repair and its cost before fixing it.
- Heat pumps installed by another company that need a second opinion
- Outdoor units that have become noisy, iced up or keep switching on and off
- Heat pumps showing an error code or fault light
What's included
- System refill, venting and recommissioning after the repair
- Testing of sensors, pumps, valves, pressures and electrics
- Supply and fitting of replacement parts
- Refrigerant repairs by an F-gas certified engineer where needed
- A clear explanation of the fault and a price for the repair before work goes ahead
We repair heat pumps in Keady whoever installed them, including older monobloc and split systems.
Grants and rules for heat pumps in Northern Ireland
The Boiler Upgrade Scheme covers England and Wales only, and there is currently no dedicated heat pump grant for homeowners in Northern Ireland. Our quote for a Keady home is therefore shown without a grant deduction; if support becomes available we will tell you how it applies.
Heat pump repairs prices in Keady
These are guide prices including VAT. The rate for your visit in Keady is confirmed before we book it, and any repair is priced in writing before parts are ordered.
| Repair | Guide price |
|---|---|
| Fault-finding visit and diagnosis | £90–£170 |
| Sensor or thermistor replacement | £120–£270 |
| Expansion vessel or pressure relief valve | £150–£340 |
| Circulating pump replacement | £240–£470 |
| Fan motor replacement | £290–£630 |
| Refrigerant leak repair and re-gas (split systems) | £340–£920 |
| Main control board (PCB) replacement | £440–£1,050 |
Inc VAT. The fault-finding rate is agreed before we attend; repairs are priced in writing before parts are ordered.
Winter daylight and heating in Keady
Keady sees roughly 7 hours 19 minutes of daylight in December and 17 hours 12 minutes in June. With a longer heating season than the south, the gains from low flow temperatures and good controls add up over the year.
How a visit works in Keady
- Tell us the make if you know it, the error code or symptoms, and send photos of the unit and controller.
- We confirm the fault-finding rate and arrange a visit in Keady.
- The engineer diagnoses the fault and gives you a written price for the repair.
- Parts are ordered once you agree, and the repair is completed and tested.
Heat pump repairs in Keady: questions
Can you work on a heat pump in Keady that someone else installed?
Yes. We arrange servicing and repairs for most air source heat pumps in Keady, whoever fitted them. Tell us the make and model when you get in touch.
Will the engineer need access indoors as well as outside?
Usually yes. The outdoor unit, the hot water cylinder, the controls and the pipework and valves indoors are all part of the visit, so allow access to each.
Do you also cover Armagh?
Yes. We arrange heat pump servicing and repairs in Armagh, which is about 7 miles north of Keady, and across County Armagh.
Why is my heat pump showing an error code?
An error code is the heat pump's way of reporting a problem it has detected, such as low water flow, a sensor reading out of range or a communication fault between units. Note the code and check the manual, as some codes clear after a simple reset or pressure top-up. If it returns, an engineer can trace the underlying cause.
How much does a heat pump repair cost?
Heat pump repairs have a typical range of £90–£1,100, including VAT, depending on the part and labour involved. Sensor replacements sit at the lower end, while control boards and refrigerant repairs on split systems sit higher. Every repair starts with a fault-finding visit, with a guide price of £90–£180 for the first hour, and the repair is priced before work goes ahead.