- Area
- Greater London
- Postcode district
- SW11
- Nation
- England
- Guide price
- From £100 inc VAT
- Visit
- Rate agreed in advance
Heat pump repairs in Battersea: what to expect
Aftercare matters as much as installation. For a heat pump in Battersea the visit checks the outdoor unit, the water circuit and the controls, and the engineer explains any settings that would help the system run more efficiently.
Repairs in Battersea that need a part ordered are explained and priced before the engineer leaves. For repeated faults in Battersea, the engineer looks at the system design as well as the failed part.
When a heat pump shows an error, loses pressure or stops heating, an engineer diagnoses the cause and explains the repair and its cost before fixing it.
- Systems losing pressure or needing frequent topping up
- Heat pumps showing an error code or fault light
- Rooms or hot water not getting warm enough
What's included
- Reading of error history and operating data
- Fault-finding visit at a rate agreed before attending
- Supply and fitting of replacement parts
- Testing of sensors, pumps, valves, pressures and electrics
- Refrigerant repairs by an F-gas certified engineer where needed
Across Battersea and Greater London, refrigerant repairs on split systems are carried out by an F-gas certified engineer.
Grants and rules for heat pumps in England
In England the Boiler Upgrade Scheme gives £7,500 towards an air source heat pump (£9,000 if it replaces oil or LPG, from 21 July 2026 to 31 March 2027), and since 28 April 2026 a valid EPC is no longer needed. The grant is applied for by the MCS-certified installer and shown as a deduction on your Battersea quote.
Heat pump repairs costs around Battersea
Guide prices for Greater London, including VAT. We agree the visit rate before anyone attends, so there are no surprises on the day.
| Repair | Guide price |
|---|---|
| Fault-finding visit and diagnosis | £100–£200 |
| Sensor or thermistor replacement | £130–£310 |
| Expansion vessel or pressure relief valve | £170–£390 |
| Circulating pump replacement | £280–£540 |
| Fan motor replacement | £340–£730 |
| Refrigerant leak repair and re-gas (split systems) | £390–£1,050 |
| Main control board (PCB) replacement | £500–£1,250 |
Inc VAT. The fault-finding rate is agreed before we attend; repairs are priced in writing before parts are ordered.
Winter daylight and heating in Battersea
Battersea sees roughly 7 hours 50 minutes of daylight in late December against 16 hours 38 minutes in June. Milder southern winters suit heat pumps well, though the system is still sized for a cold snap rather than an average day.
How a visit works in Battersea
- Tell us the make if you know it, the error code or symptoms, and send photos of the unit and controller.
- We confirm the fault-finding rate and arrange a visit in Battersea.
- The engineer diagnoses the fault and gives you a written price for the repair.
- Parts are ordered once you agree, and the repair is completed and tested.
Heat pump repairs in Battersea: questions
Do you also cover Chelsea?
Yes. We arrange heat pump servicing and repairs in Chelsea, which is about a mile north of Battersea, and across Greater London.
Will the engineer need access indoors as well as outside?
Usually yes. The outdoor unit, the hot water cylinder, the controls and the pipework and valves indoors are all part of the visit, so allow access to each.
How much does a visit cost in Battersea?
The rate for a service or fault-finding visit is agreed before anyone attends. Any repair is priced in writing before parts are ordered, so you decide before work goes ahead.
Why does my heat pump keep switching on and off?
Frequent starting and stopping, called short cycling, is usually caused by an oversized heat pump, low water flow, too many zones closing at once or controls set with too narrow a range. It reduces efficiency and wears components. An engineer can check the settings, flow rates and design, and can often improve it with control changes before any parts are needed.
Can you repair a heat pump installed by another company?
Yes. We carry out fault-finding and repairs on heat pumps installed by other companies, including monobloc and split systems. Tell us the make, model and approximate age when you get in touch, plus any error code shown. If the system is still under the manufacturer's warranty, it may be quicker to contact the original installer or manufacturer first.