- Area
- Greater London
- Postcode district
- NW11
- Nation
- England
- Guide price
- From £100 inc VAT
- Visit
- Rate agreed in advance
What to know about heat pump repairs in Golders Green
Aftercare matters as much as installation. For a heat pump in Golders Green the visit checks the outdoor unit, the water circuit and the controls, and the engineer explains any settings that would help the system run more efficiently.
We repair heat pumps in Golders Green whoever installed them, including older monobloc and split systems. Across Golders Green and Greater London, refrigerant repairs on split systems are carried out by an F-gas certified engineer.
When a heat pump shows an error, loses pressure or stops heating, an engineer diagnoses the cause and explains the repair and its cost before fixing it.
- Rooms or hot water not getting warm enough
- Systems losing pressure or needing frequent topping up
- Heat pumps showing an error code or fault light
What's included
- Supply and fitting of replacement parts
- Refrigerant repairs by an F-gas certified engineer where needed
- Testing of sensors, pumps, valves, pressures and electrics
- Reading of error history and operating data
- Fault-finding visit at a rate agreed before attending
Heat pump owners in Golders Green can arrange a fault-finding visit at a rate agreed before an engineer attends.
Grants and rules for heat pumps in England
In England the Boiler Upgrade Scheme gives £7,500 towards an air source heat pump (£9,000 if it replaces oil or LPG, from 21 July 2026 to 31 March 2027), and since 28 April 2026 a valid EPC is no longer needed. The grant is applied for by the MCS-certified installer and shown as a deduction on your Golders Green quote.
What to budget for heat pump repairs in Golders Green
Guide prices for Greater London, including VAT. We agree the visit rate before anyone attends, so there are no surprises on the day.
| Repair | Guide price |
|---|---|
| Fault-finding visit and diagnosis | £100–£200 |
| Sensor or thermistor replacement | £130–£310 |
| Expansion vessel or pressure relief valve | £170–£390 |
| Circulating pump replacement | £280–£540 |
| Fan motor replacement | £340–£730 |
| Refrigerant leak repair and re-gas (split systems) | £390–£1,050 |
| Main control board (PCB) replacement | £500–£1,250 |
Inc VAT. The fault-finding rate is agreed before we attend; repairs are priced in writing before parts are ordered.
How long is the heating season in Golders Green?
Golders Green sees roughly 7 hours 49 minutes of daylight in late December against 16 hours 39 minutes in June. Milder southern winters suit heat pumps well, though the system is still sized for a cold snap rather than an average day.
Booking a visit in Golders Green
- Tell us the make if you know it, the error code or symptoms, and send photos of the unit and controller.
- We confirm the fault-finding rate and arrange a visit in Golders Green.
- The engineer diagnoses the fault and gives you a written price for the repair.
- Parts are ordered once you agree, and the repair is completed and tested.
Heat pump repairs in Golders Green: questions
Do you also cover Hampstead?
Yes. We arrange heat pump servicing and repairs in Hampstead, which is about a mile south-east of Golders Green, and across Greater London.
How often should a heat pump in Golders Green be serviced?
Once a year is the usual recommendation, and many manufacturers make annual servicing a condition of the warranty. Check your warranty terms for the exact requirement.
Can you work on a heat pump in Golders Green that someone else installed?
Yes. We arrange servicing and repairs for most air source heat pumps in Golders Green, whoever fitted them. Tell us the make and model when you get in touch.
Why does my heat pump keep switching on and off?
Frequent starting and stopping, called short cycling, is usually caused by an oversized heat pump, low water flow, too many zones closing at once or controls set with too narrow a range. It reduces efficiency and wears components. An engineer can check the settings, flow rates and design, and can often improve it with control changes before any parts are needed.
Can you repair a heat pump installed by another company?
Yes. We carry out fault-finding and repairs on heat pumps installed by other companies, including monobloc and split systems. Tell us the make, model and approximate age when you get in touch, plus any error code shown. If the system is still under the manufacturer's warranty, it may be quicker to contact the original installer or manufacturer first.