- Area
- Herefordshire
- Postcode district
- HR6
- Nation
- England
- Guide price
- From £90 inc VAT
- Visit
- Rate agreed in advance
Heat pump repairs in Leominster: what to expect
Aftercare matters as much as installation. For a heat pump in Leominster the visit checks the outdoor unit, the water circuit and the controls, and the engineer explains any settings that would help the system run more efficiently.
Outdoor units in exposed spots around Leominster can ice more heavily, so siting is checked as part of any icing fault. We repair heat pumps in Leominster whoever installed them, including older monobloc and split systems.
When a heat pump shows an error, loses pressure or stops heating, an engineer diagnoses the cause and explains the repair and its cost before fixing it.
- Systems losing pressure or needing frequent topping up
- Rooms or hot water not getting warm enough
- Heat pumps installed by another company that need a second opinion
What's included
- Refrigerant repairs by an F-gas certified engineer where needed
- Fault-finding visit at a rate agreed before attending
- Supply and fitting of replacement parts
- Reading of error history and operating data
- System refill, venting and recommissioning after the repair
Across Leominster and Herefordshire, refrigerant repairs on split systems are carried out by an F-gas certified engineer.
Grants and rules for heat pumps in England
In England the Boiler Upgrade Scheme gives £7,500 towards an air source heat pump (£9,000 if it replaces oil or LPG, from 21 July 2026 to 31 March 2027), and since 28 April 2026 a valid EPC is no longer needed. The grant is applied for by the MCS-certified installer and shown as a deduction on your Leominster quote.
Heat pump repairs costs around Leominster
These are guide prices including VAT. The rate for your visit in Leominster is confirmed before we book it, and any repair is priced in writing before parts are ordered.
| Repair | Guide price |
|---|---|
| Fault-finding visit and diagnosis | £90–£180 |
| Sensor or thermistor replacement | £120–£280 |
| Expansion vessel or pressure relief valve | £150–£350 |
| Circulating pump replacement | £250–£480 |
| Fan motor replacement | £300–£650 |
| Refrigerant leak repair and re-gas (split systems) | £350–£950 |
| Main control board (PCB) replacement | £450–£1,100 |
Inc VAT. The fault-finding rate is agreed before we attend; repairs are priced in writing before parts are ordered.
Short winter days in Leominster and what they mean
On the shortest day Leominster gets about 7 hours 42 minutes of daylight, with the noon sun around 14° up. The heating season runs from autumn into spring, so a heat pump that is sized correctly and set up with weather compensation does most of its work in steady, cool conditions.
Booking a visit in Leominster
- Tell us the make if you know it, the error code or symptoms, and send photos of the unit and controller.
- We confirm the fault-finding rate and arrange a visit in Leominster.
- The engineer diagnoses the fault and gives you a written price for the repair.
- Parts are ordered once you agree, and the repair is completed and tested.
Heat pump repairs in Leominster: questions
What should I check before booking a visit in Leominster?
Note any error code on the controller, check the system pressure gauge if you have one, and make sure the outdoor unit is clear of leaves or snow. Photos of the unit and controller help.
Do you also cover Tenbury Wells?
Yes. We arrange heat pump servicing and repairs in Tenbury Wells, which is about 9 miles north-east of Leominster, and across Herefordshire.
Can you work on a heat pump in Leominster that someone else installed?
Yes. We arrange servicing and repairs for most air source heat pumps in Leominster, whoever fitted them. Tell us the make and model when you get in touch.
Why does my heat pump keep switching on and off?
Frequent starting and stopping, called short cycling, is usually caused by an oversized heat pump, low water flow, too many zones closing at once or controls set with too narrow a range. It reduces efficiency and wears components. An engineer can check the settings, flow rates and design, and can often improve it with control changes before any parts are needed.
Can you repair a heat pump installed by another company?
Yes. We carry out fault-finding and repairs on heat pumps installed by other companies, including monobloc and split systems. Tell us the make, model and approximate age when you get in touch, plus any error code shown. If the system is still under the manufacturer's warranty, it may be quicker to contact the original installer or manufacturer first.