- Area
- Lancashire
- Postcode district
- BB10
- Nation
- England
- Guide price
- From £90 inc VAT
- Visit
- Rate agreed in advance
Before you book: heat pump repairs in Burnley
Aftercare matters as much as installation. For a heat pump in Burnley the visit checks the outdoor unit, the water circuit and the controls, and the engineer explains any settings that would help the system run more efficiently.
Heat pump owners in Burnley can arrange a fault-finding visit at a rate agreed before an engineer attends. We repair heat pumps in Burnley whoever installed them, including older monobloc and split systems.
When a heat pump shows an error, loses pressure or stops heating, an engineer diagnoses the cause and explains the repair and its cost before fixing it.
- Outdoor units that have become noisy, iced up or keep switching on and off
- Rooms or hot water not getting warm enough
- Heat pumps showing an error code or fault light
What's included
- Reading of error history and operating data
- Supply and fitting of replacement parts
- A clear explanation of the fault and a price for the repair before work goes ahead
- System refill, venting and recommissioning after the repair
- Testing of sensors, pumps, valves, pressures and electrics
Across Burnley and Lancashire, refrigerant repairs on split systems are carried out by an F-gas certified engineer.
Grants and rules for heat pumps in England
Homes in Burnley can use the Boiler Upgrade Scheme, which takes £7,500 off the cost of an air source heat pump when it replaces fossil-fuel or electric heating. Replacing oil or LPG heating qualifies for £9,000 for installations from 21 July 2026 to 31 March 2027, and air-to-air systems for £2,500. The MCS-certified installer named in your quote applies for the grant and deducts it from the price.
What to budget for heat pump repairs in Burnley
Guide prices for Lancashire, including VAT. We agree the visit rate before anyone attends, so there are no surprises on the day.
| Repair | Guide price |
|---|---|
| Fault-finding visit and diagnosis | £90–£180 |
| Sensor or thermistor replacement | £120–£270 |
| Expansion vessel or pressure relief valve | £150–£340 |
| Circulating pump replacement | £240–£470 |
| Fan motor replacement | £290–£640 |
| Refrigerant leak repair and re-gas (split systems) | £340–£930 |
| Main control board (PCB) replacement | £440–£1,100 |
Inc VAT. The fault-finding rate is agreed before we attend; repairs are priced in writing before parts are ordered.
Designing for Burnley's winters
Burnley sees roughly 7 hours 24 minutes of daylight in December and 17 hours 06 minutes in June. With a longer heating season than the south, the gains from low flow temperatures and good controls add up over the year.
Booking a visit in Burnley
- Tell us the make if you know it, the error code or symptoms, and send photos of the unit and controller.
- We confirm the fault-finding rate and arrange a visit in Burnley.
- The engineer diagnoses the fault and gives you a written price for the repair.
- Parts are ordered once you agree, and the repair is completed and tested.
Heat pump repairs in Burnley: questions
How much does a visit cost in Burnley?
The rate for a service or fault-finding visit is agreed before anyone attends. Any repair is priced in writing before parts are ordered, so you decide before work goes ahead.
Do you also cover Colne?
Yes. We arrange heat pump servicing and repairs in Colne, which is about 5 miles north-east of Burnley, and across Lancashire.
Can you work on a heat pump in Burnley that someone else installed?
Yes. We arrange servicing and repairs for most air source heat pumps in Burnley, whoever fitted them. Tell us the make and model when you get in touch.
How much does a heat pump repair cost?
Heat pump repairs have a typical range of £90–£1,100, including VAT, depending on the part and labour involved. Sensor replacements sit at the lower end, while control boards and refrigerant repairs on split systems sit higher. Every repair starts with a fault-finding visit, with a guide price of £90–£180 for the first hour, and the repair is priced before work goes ahead.
Is ice on my heat pump a fault?
Some frost on the outdoor unit in cold, damp weather is normal, and the unit clears it with regular defrost cycles, often releasing a little vapour. It becomes a fault when thick ice builds up and does not clear, or when ice blocks the fan. That can point to poor airflow, a failed sensor, drainage problems or low refrigerant, and needs checking.