- Area
- North Yorkshire
- Postcode district
- TS15
- Nation
- England
- Guide price
- From £90 inc VAT
- Visit
- Rate agreed in advance
Heat pump repairs for Yarm homes
Aftercare matters as much as installation. For a heat pump in Yarm the visit checks the outdoor unit, the water circuit and the controls, and the engineer explains any settings that would help the system run more efficiently.
For repeated faults in Yarm, the engineer looks at the system design as well as the failed part. We repair heat pumps in Yarm whoever installed them, including older monobloc and split systems.
When a heat pump shows an error, loses pressure or stops heating, an engineer diagnoses the cause and explains the repair and its cost before fixing it.
- Systems losing pressure or needing frequent topping up
- Heat pumps showing an error code or fault light
- Heat pumps installed by another company that need a second opinion
What's included
- Fault-finding visit at a rate agreed before attending
- A clear explanation of the fault and a price for the repair before work goes ahead
- Reading of error history and operating data
- Testing of sensors, pumps, valves, pressures and electrics
- Supply and fitting of replacement parts
Heat pump owners in Yarm can arrange a fault-finding visit at a rate agreed before an engineer attends.
Grants and rules for heat pumps in England
Homes in Yarm can use the Boiler Upgrade Scheme, which takes £7,500 off the cost of an air source heat pump when it replaces fossil-fuel or electric heating. Replacing oil or LPG heating qualifies for £9,000 for installations from 21 July 2026 to 31 March 2027, and air-to-air systems for £2,500. The MCS-certified installer named in your quote applies for the grant and deducts it from the price.
Heat pump repairs costs around Yarm
These are guide prices including VAT. The rate for your visit in Yarm is confirmed before we book it, and any repair is priced in writing before parts are ordered.
| Repair | Guide price |
|---|---|
| Fault-finding visit and diagnosis | £90–£180 |
| Sensor or thermistor replacement | £120–£280 |
| Expansion vessel or pressure relief valve | £150–£350 |
| Circulating pump replacement | £250–£480 |
| Fan motor replacement | £300–£650 |
| Refrigerant leak repair and re-gas (split systems) | £350–£950 |
| Main control board (PCB) replacement | £450–£1,100 |
Inc VAT. The fault-finding rate is agreed before we attend; repairs are priced in writing before parts are ordered.
Designing for Yarm's winters
Yarm sees roughly 7 hours 16 minutes of daylight in December and 17 hours 15 minutes in June. With a longer heating season than the south, the gains from low flow temperatures and good controls add up over the year.
Booking a visit in Yarm
- Tell us the make if you know it, the error code or symptoms, and send photos of the unit and controller.
- We confirm the fault-finding rate and arrange a visit in Yarm.
- The engineer diagnoses the fault and gives you a written price for the repair.
- Parts are ordered once you agree, and the repair is completed and tested.
Heat pump repairs in Yarm: questions
How often should a heat pump in Yarm be serviced?
Once a year is the usual recommendation, and many manufacturers make annual servicing a condition of the warranty. Check your warranty terms for the exact requirement.
Can you work on a heat pump in Yarm that someone else installed?
Yes. We arrange servicing and repairs for most air source heat pumps in Yarm, whoever fitted them. Tell us the make and model when you get in touch.
Will the engineer need access indoors as well as outside?
Usually yes. The outdoor unit, the hot water cylinder, the controls and the pipework and valves indoors are all part of the visit, so allow access to each.
Is ice on my heat pump a fault?
Some frost on the outdoor unit in cold, damp weather is normal, and the unit clears it with regular defrost cycles, often releasing a little vapour. It becomes a fault when thick ice builds up and does not clear, or when ice blocks the fan. That can point to poor airflow, a failed sensor, drainage problems or low refrigerant, and needs checking.
Do refrigerant repairs need a specialist?
Yes. Any work on a heat pump's refrigerant circuit, such as tracing a leak, replacing a component or re-gassing, must by law be done by an F-gas certified engineer where the refrigerant is fluorinated, such as R32; units using R290 (propane) need an engineer trained in flammable refrigerants. On split systems the refrigerant runs through pipes inside your home, so leaks there are more likely than on sealed monobloc units.