- Area
- West Yorkshire
- Postcode district
- LS19
- Nation
- England
- Guide price
- From £90 inc VAT
- Visit
- Rate agreed in advance
Heat pump repairs in Yeadon: what to expect
Whoever installed your heat pump, aftercare can be arranged in Yeadon. Tell us the make and model and roughly how old it is, and we will set out what the visit involves before you book.
Repairs in Yeadon that need a part ordered are explained and priced before the engineer leaves. We repair heat pumps in Yeadon whoever installed them, including older monobloc and split systems.
When a heat pump shows an error, loses pressure or stops heating, an engineer diagnoses the cause and explains the repair and its cost before fixing it.
- Rooms or hot water not getting warm enough
- Systems losing pressure or needing frequent topping up
- Heat pumps installed by another company that need a second opinion
What's included
- Supply and fitting of replacement parts
- Reading of error history and operating data
- Testing of sensors, pumps, valves, pressures and electrics
- System refill, venting and recommissioning after the repair
- Refrigerant repairs by an F-gas certified engineer where needed
Heat pump owners in Yeadon can arrange a fault-finding visit at a rate agreed before an engineer attends.
Grants and rules for heat pumps in England
In England the Boiler Upgrade Scheme gives £7,500 towards an air source heat pump (£9,000 if it replaces oil or LPG, from 21 July 2026 to 31 March 2027), and since 28 April 2026 a valid EPC is no longer needed. The grant is applied for by the MCS-certified installer and shown as a deduction on your Yeadon quote.
Heat pump repairs costs around Yeadon
These are guide prices including VAT. The rate for your visit in Yeadon is confirmed before we book it, and any repair is priced in writing before parts are ordered.
| Repair | Guide price |
|---|---|
| Fault-finding visit and diagnosis | £90–£180 |
| Sensor or thermistor replacement | £120–£270 |
| Expansion vessel or pressure relief valve | £150–£340 |
| Circulating pump replacement | £240–£470 |
| Fan motor replacement | £290–£640 |
| Refrigerant leak repair and re-gas (split systems) | £340–£930 |
| Main control board (PCB) replacement | £440–£1,100 |
Inc VAT. The fault-finding rate is agreed before we attend; repairs are priced in writing before parts are ordered.
Winter daylight and heating in Yeadon
Yeadon sees roughly 7 hours 24 minutes of daylight in December and 17 hours 07 minutes in June. With a longer heating season than the south, the gains from low flow temperatures and good controls add up over the year.
What happens when you book in Yeadon?
- Tell us the make if you know it, the error code or symptoms, and send photos of the unit and controller.
- We confirm the fault-finding rate and arrange a visit in Yeadon.
- The engineer diagnoses the fault and gives you a written price for the repair.
- Parts are ordered once you agree, and the repair is completed and tested.
Heat pump repairs in Yeadon: questions
What should I check before booking a visit in Yeadon?
Note any error code on the controller, check the system pressure gauge if you have one, and make sure the outdoor unit is clear of leaves or snow. Photos of the unit and controller help.
Do you also cover Guiseley?
Yes. We arrange heat pump servicing and repairs in Guiseley, which is about a mile north-west of Yeadon, and across West Yorkshire.
Will the engineer need access indoors as well as outside?
Usually yes. The outdoor unit, the hot water cylinder, the controls and the pipework and valves indoors are all part of the visit, so allow access to each.
Why does my heat pump keep switching on and off?
Frequent starting and stopping, called short cycling, is usually caused by an oversized heat pump, low water flow, too many zones closing at once or controls set with too narrow a range. It reduces efficiency and wears components. An engineer can check the settings, flow rates and design, and can often improve it with control changes before any parts are needed.
Can you repair a heat pump installed by another company?
Yes. We carry out fault-finding and repairs on heat pumps installed by other companies, including monobloc and split systems. Tell us the make, model and approximate age when you get in touch, plus any error code shown. If the system is still under the manufacturer's warranty, it may be quicker to contact the original installer or manufacturer first.