- Area
- Glasgow and Dunbartonshire
- Postcode district
- G2
- Nation
- Scotland
- Guide price
- From £120 inc VAT
- Visit
- Rate agreed in advance
Heat pump servicing in Glasgow: what to expect
A heat pump that is serviced and set up properly keeps running efficiently for many years. Many heat pump faults trace back to settings, low pressure or a worn part rather than the heat pump itself, and those can usually be put right.
Service visits in Glasgow include unvented cylinder safety checks alongside the heat pump itself. Heat pumps in Glasgow that sit near trees or hedges often need their outdoor coil cleared of leaves at the annual service.
An annual service keeps a heat pump running efficiently, catches small faults early and is often a condition of the manufacturer's warranty.
- Heat pumps installed by another company that need a new servicing arrangement
- Systems where the manufacturer's warranty requires annual servicing
- Heat pumps a year or more past installation
What's included
- Controls and error log check, with settings adjusted where needed
- Cleaning of the outdoor unit coil, fan area and condensate drain
- Glycol or antifreeze protection test where fitted
- Refrigerant circuit checks on split systems by an F-gas certified engineer
- Unvented cylinder safety checks and legionella cycle check
Landlords in Glasgow can arrange servicing for several properties, with a dated record for each.
Grants and rules for heat pumps in Scotland
In Scotland, heat pump funding comes through Home Energy Scotland rather than the Boiler Upgrade Scheme: a grant of up to £7,500 (up to £1,500 extra for eligible rural and island homes) and an optional interest-free loan of up to £7,500. For a Glasgow home, apply and receive the written offer before the installation date is fixed.
Heat pump servicing costs around Glasgow
These are guide prices including VAT. The rate for your visit in Glasgow is confirmed before we book it, and any repair is priced in writing before parts are ordered.
| Visit | Guide price |
|---|---|
| Annual heat pump service | £120–£250 |
| Fault-finding visit (first hour) | £90–£180 |
Inc VAT. The rate for your visit is confirmed before booking.
Short winter days in Glasgow and what they mean
On the shortest day Glasgow gets only about 6 hours 59 minutes of daylight, with the sun around 11° up at noon. Long Scottish winters mean the heat pump runs for much of the year, so careful sizing, good controls and correctly sized radiators make a real difference.
Booking a visit in Glasgow
- Book a service and tell us roughly how old the system is.
- An engineer visits your Glasgow home and works through the service checklist.
- You receive a written record of the service and any recommendations.
- If a repair is needed, it is priced in writing before any work goes ahead.
Heat pump servicing in Glasgow: questions
Do you also cover Bishopbriggs?
Yes. We arrange heat pump servicing and repairs in Bishopbriggs, which is about 3 miles north-east of Glasgow, and across Glasgow and Dunbartonshire.
Will the engineer need access indoors as well as outside?
Usually yes. The outdoor unit, the hot water cylinder, the controls and the pipework and valves indoors are all part of the visit, so allow access to each.
What should I check before booking a visit in Glasgow?
Note any error code on the controller, check the system pressure gauge if you have one, and make sure the outdoor unit is clear of leaves or snow. Photos of the unit and controller help.
Can you service a split system?
Yes. Split systems have refrigerant pipes running between the outdoor unit and an indoor unit, and checks on that refrigerant circuit must be done by an F-gas certified engineer. We arrange the service so a suitably certified engineer attends. The water side, controls and cylinder are checked in the same visit, just as on a monobloc system.
How often should a heat pump be serviced?
Once a year is the usual recommendation for air source heat pumps, and many manufacturers require it as a warranty condition. An annual visit cleans filters and strainers, checks pressures and controls, and tests the unvented cylinder's safety devices. If you notice a drop in performance, unusual noises or repeated error codes between services, arrange a visit sooner.