- Area
- Greater London
- Postcode district
- UB8
- Nation
- England
- Guide price
- From £130 inc VAT
- Visit
- Rate agreed in advance
Heat pump servicing for Uxbridge homes
A heat pump that is serviced and set up properly keeps running efficiently for many years. Many heat pump faults trace back to settings, low pressure or a worn part rather than the heat pump itself, and those can usually be put right.
If a heat pump in Uxbridge has not been serviced for a while, the first visit includes a full check of settings and pressures. Homes in Uxbridge and across Greater London can book servicing at a time of year that suits them, ideally before winter.
An annual service keeps a heat pump running efficiently, catches small faults early and is often a condition of the manufacturer's warranty.
- Systems where the manufacturer's warranty requires annual servicing
- Homes where running costs have crept up or rooms feel cooler than before
- Landlords who need dated service records for each property
What's included
- Glycol or antifreeze protection test where fitted
- A dated service record for your warranty and property files
- Unvented cylinder safety checks and legionella cycle check
- Refrigerant circuit checks on split systems by an F-gas certified engineer
- Cleaning of the outdoor unit coil, fan area and condensate drain
Heat pumps in Uxbridge that sit near trees or hedges often need their outdoor coil cleared of leaves at the annual service.
Grants and rules for heat pumps in England
Homes in Uxbridge can use the Boiler Upgrade Scheme, which takes £7,500 off the cost of an air source heat pump when it replaces fossil-fuel or electric heating. Replacing oil or LPG heating qualifies for £9,000 for installations from 21 July 2026 to 31 March 2027, and air-to-air systems for £2,500. The MCS-certified installer named in your quote applies for the grant and deducts it from the price.
What to budget for heat pump servicing in Uxbridge
Guide prices for Greater London, including VAT. We agree the visit rate before anyone attends, so there are no surprises on the day.
| Visit | Guide price |
|---|---|
| Annual heat pump service | £130–£280 |
| Fault-finding visit (first hour) | £100–£200 |
Inc VAT. The rate for your visit is confirmed before booking.
How long is the heating season in Uxbridge?
On the shortest day Uxbridge gets about 7 hours 49 minutes of daylight, and the winter sun reaches only around 15° above the horizon at noon. Winters this far south are milder than in most of the UK, which helps a heat pump run at low flow temperatures for much of the season.
How a visit works in Uxbridge
- Book a service and tell us roughly how old the system is.
- An engineer visits your Uxbridge home and works through the service checklist.
- You receive a written record of the service and any recommendations.
- If a repair is needed, it is priced in writing before any work goes ahead.
Heat pump servicing in Uxbridge: questions
Will the engineer need access indoors as well as outside?
Usually yes. The outdoor unit, the hot water cylinder, the controls and the pipework and valves indoors are all part of the visit, so allow access to each.
How much does a visit cost in Uxbridge?
The rate for a service or fault-finding visit is agreed before anyone attends. Any repair is priced in writing before parts are ordered, so you decide before work goes ahead.
Do you also cover Ruislip?
Yes. We arrange heat pump servicing and repairs in Ruislip, which is about 3 miles north-east of Uxbridge, and across Greater London.
Do I need to do anything between services?
A little. Keep the area around the outdoor unit clear of leaves, snow, plants and stored items so air flows freely. Check the system pressure gauge occasionally if you have one, and note any error codes. Avoid covering the unit or building an enclosure around it without advice, as this can reduce performance.
Can you service a split system?
Yes. Split systems have refrigerant pipes running between the outdoor unit and an indoor unit, and checks on that refrigerant circuit must be done by an F-gas certified engineer. We arrange the service so a suitably certified engineer attends. The water side, controls and cylinder are checked in the same visit, just as on a monobloc system.