- Area
- Lancashire
- Postcode district
- PR1
- Nation
- England
- Guide price
- From £120 inc VAT
- Visit
- Rate agreed in advance
Heat pump servicing for Preston homes
Aftercare matters as much as installation. For a heat pump in Preston the visit checks the outdoor unit, the water circuit and the controls, and the engineer explains any settings that would help the system run more efficiently.
Landlords in Preston can arrange servicing for several properties, with a dated record for each. If a heat pump in Preston has not been serviced for a while, the first visit includes a full check of settings and pressures.
An annual service keeps a heat pump running efficiently, catches small faults early and is often a condition of the manufacturer's warranty.
- Homes where running costs have crept up or rooms feel cooler than before
- Systems where the manufacturer's warranty requires annual servicing
- Heat pumps a year or more past installation
What's included
- Expansion vessel, pressure relief and water quality checks
- A dated service record for your warranty and property files
- Refrigerant circuit checks on split systems by an F-gas certified engineer
- Cleaning of the outdoor unit coil, fan area and condensate drain
- Magnetic filter and strainer clean, with system pressure topped up
We service heat pumps in Preston whoever installed them, including monobloc and split systems.
Grants and rules for heat pumps in England
Homes in Preston can use the Boiler Upgrade Scheme, which takes £7,500 off the cost of an air source heat pump when it replaces fossil-fuel or electric heating. Replacing oil or LPG heating qualifies for £9,000 for installations from 21 July 2026 to 31 March 2027, and air-to-air systems for £2,500. The MCS-certified installer named in your quote applies for the grant and deducts it from the price.
Heat pump servicing prices in Preston
These are guide prices including VAT. The rate for your visit in Preston is confirmed before we book it, and any repair is priced in writing before parts are ordered.
| Visit | Guide price |
|---|---|
| Annual heat pump service | £120–£240 |
| Fault-finding visit (first hour) | £90–£180 |
Inc VAT. The rate for your visit is confirmed before booking.
How long is the heating season in Preston?
On the shortest day Preston gets only about 7 hours 25 minutes of daylight and the noon sun sits around 13° above the horizon. Northern winters tend to be longer, so a well-designed, efficient system matters more here because it runs for more of the year.
What happens when you book in Preston?
- Book a service and tell us roughly how old the system is.
- An engineer visits your Preston home and works through the service checklist.
- You receive a written record of the service and any recommendations.
- If a repair is needed, it is priced in writing before any work goes ahead.
Heat pump servicing in Preston: questions
Do you also cover Leyland?
Yes. We arrange heat pump servicing and repairs in Leyland, which is about 5 miles south of Preston, and across Lancashire.
What should I check before booking a visit in Preston?
Note any error code on the controller, check the system pressure gauge if you have one, and make sure the outdoor unit is clear of leaves or snow. Photos of the unit and controller help.
Can you work on a heat pump in Preston that someone else installed?
Yes. We arrange servicing and repairs for most air source heat pumps in Preston, whoever fitted them. Tell us the make and model when you get in touch.
How much does a heat pump service cost?
An annual heat pump service has a guide price of £120–£250, including VAT. Where your price sits depends on the type of system, whether it is a split system needing refrigerant checks and whether an unvented cylinder is included. Any parts or repairs found during the service are explained and priced before any work goes ahead.
Do I need to do anything between services?
A little. Keep the area around the outdoor unit clear of leaves, snow, plants and stored items so air flows freely. Check the system pressure gauge occasionally if you have one, and note any error codes. Avoid covering the unit or building an enclosure around it without advice, as this can reduce performance.