- Area
- Oxfordshire
- Postcode district
- OX10
- Nation
- England
- Guide price
- From £2,500 inc VAT
- Survey
- Free for installation enquiries
Air-to-air heat pumps for Wallingford homes
The question for a Wallingford home is rarely whether a heat pump can work, but what needs to change to make it work well: radiator sizes, pipework, controls and where the unit goes.
Flats in Wallingford on storage or panel heaters can often switch to air-to-air without fitting radiators or pipework. A survey in Wallingford covers indoor unit positions, pipe routes and hot water for homes across Oxfordshire.
An air-to-air heat pump warms rooms directly with air, and can cool them in summer, but it does not heat your hot water.
- Homes where fitting radiators and pipework would be very disruptive
- Flats and apartments with storage or panel heaters
- Households that already have, or will add, a separate source of hot water
What's included
- Condensate drains and neat external pipe covers
- Free survey covering rooms to heat, unit positions and hot water options
- Electrical supply and controls set up for each room
- Commissioning, MCS certificate and the air-to-air grant claim in England and Wales where eligible
- Refrigerant pipe runs to each indoor unit, made and charged by an F-gas certified engineer
Top-floor rooms in Wallingford that overheat in summer gain from the cooling an air-to-air system provides.
Grants and rules for heat pumps in England
Homes in Wallingford can use the Boiler Upgrade Scheme, which takes £7,500 off the cost of an air source heat pump when it replaces fossil-fuel or electric heating. Replacing oil or LPG heating qualifies for £9,000 for installations from 21 July 2026 to 31 March 2027, and air-to-air systems for £2,500. The MCS-certified installer named in your quote applies for the grant and deducts it from the price.
There is no VAT on installing a heat pump anywhere in the UK until 31 March 2027. In England most houses can have an air source heat pump under permitted development, provided the unit meets the MCS noise and siting standards; the old 1 m boundary limit was removed on 29 May 2025. We flag listed buildings, flats and sensitive conservation-area positions at survey.
Air-to-air heat pumps prices in Wallingford
The ranges below are typical installed prices for homes in Oxfordshire, including VAT. A survey sets the exact figure, because two similar-looking houses in Wallingford can need quite different radiators and pipework.
| System | Installed guide price |
|---|---|
| Air-to-air heat pump, 1–2 rooms | £2,500–£5,200 |
| Air-to-air heat pump, multi-room 3–4 bedroom home | £4,150–£8,300 |
Installed, inc VAT. Air-to-air systems heat (and can cool) rooms but do not provide hot water. In England and Wales the Boiler Upgrade Scheme gives £2,500 towards an air-to-air system in a home, deducted from your quote where eligible.
Winter daylight and heating in Wallingford
On the shortest day Wallingford gets about 7 hours 49 minutes of daylight, and the winter sun reaches only around 15° above the horizon at noon. Winters this far south are milder than in most of the UK, which helps a heat pump run at low flow temperatures for much of the season.
The steps for air-to-air heat pumps in Wallingford
- Tell us about your home: postcode, property type and current heating.
- We book a survey in Wallingford; the surveyor measures rooms, windows and radiators and looks at cylinder space.
- The design and quote arrive in writing, including radiator changes and the outdoor unit position.
- On installation days the old system is removed and the new one fitted and filled.
- We commission the heat pump, show you the controls and register the installation.
Air-to-air heat pumps in Wallingford: questions
Do you cover Didcot as well as Wallingford?
Yes. We arrange surveys and installation in Didcot, which is about 5 miles west of Wallingford, and across Oxfordshire.
How long does installation take in Wallingford?
Most installations take 2–4 days on site. Jobs with several radiator changes or new pipework take longer, and your quote for a Wallingford home states the expected time.
Where would the outdoor unit go on a Wallingford house?
Usually at the side or rear, on a level base with space around it for airflow and servicing, away from bedroom windows where possible. The surveyor checks positions at your Wallingford home.
Are air-to-air heat pumps suitable for flats?
Often, yes. They need no radiators, pipework or cylinder, so they suit flats heated by storage or panel heaters. You need a position for the outdoor unit, such as a balcony, wall bracket or ground-floor yard, and leaseholders normally need the freeholder's or management company's consent. Planning rules for flats differ by nation, so we check what applies at survey.
Is there a grant for air-to-air heat pumps?
In England and Wales, yes: the Boiler Upgrade Scheme includes a grant of £2,500 for air-to-air heat pumps in homes, from 28 April 2026. The MCS-certified installer applies to Ofgem and deducts it from your quote, subject to the scheme's conditions. The scheme does not cover Scotland or Northern Ireland; in Scotland, Home Energy Scotland has its own rules.