- Area
- Dorset
- Postcode district
- BH2
- Nation
- England
- Guide price
- From £90 inc VAT
- Visit
- Rate agreed in advance
What to know about heat pump repairs in Bournemouth
A heat pump that is serviced and set up properly keeps running efficiently for many years. Many heat pump faults trace back to settings, low pressure or a worn part rather than the heat pump itself, and those can usually be put right.
Repairs in Bournemouth that need a part ordered are explained and priced before the engineer leaves. For repeated faults in Bournemouth, the engineer looks at the system design as well as the failed part.
When a heat pump shows an error, loses pressure or stops heating, an engineer diagnoses the cause and explains the repair and its cost before fixing it.
- Rooms or hot water not getting warm enough
- Heat pumps showing an error code or fault light
- Outdoor units that have become noisy, iced up or keep switching on and off
What's included
- Refrigerant repairs by an F-gas certified engineer where needed
- Testing of sensors, pumps, valves, pressures and electrics
- A clear explanation of the fault and a price for the repair before work goes ahead
- Fault-finding visit at a rate agreed before attending
- Reading of error history and operating data
Heat pump owners in Bournemouth can arrange a fault-finding visit at a rate agreed before an engineer attends.
Grants and rules for heat pumps in England
In England the Boiler Upgrade Scheme gives £7,500 towards an air source heat pump (£9,000 if it replaces oil or LPG, from 21 July 2026 to 31 March 2027), and since 28 April 2026 a valid EPC is no longer needed. The grant is applied for by the MCS-certified installer and shown as a deduction on your Bournemouth quote.
Guide prices for heat pump repairs in Bournemouth
Guide prices for Dorset, including VAT. We agree the visit rate before anyone attends, so there are no surprises on the day.
| Repair | Guide price |
|---|---|
| Fault-finding visit and diagnosis | £90–£180 |
| Sensor or thermistor replacement | £120–£280 |
| Expansion vessel or pressure relief valve | £150–£350 |
| Circulating pump replacement | £250–£480 |
| Fan motor replacement | £300–£660 |
| Refrigerant leak repair and re-gas (split systems) | £350–£960 |
| Main control board (PCB) replacement | £450–£1,100 |
Inc VAT. The fault-finding rate is agreed before we attend; repairs are priced in writing before parts are ordered.
Short winter days in Bournemouth and what they mean
Bournemouth sees roughly 7 hours 57 minutes of daylight in late December against 16 hours 30 minutes in June. Milder southern winters suit heat pumps well, though the system is still sized for a cold snap rather than an average day.
What happens when you book in Bournemouth?
- Tell us the make if you know it, the error code or symptoms, and send photos of the unit and controller.
- We confirm the fault-finding rate and arrange a visit in Bournemouth.
- The engineer diagnoses the fault and gives you a written price for the repair.
- Parts are ordered once you agree, and the repair is completed and tested.
Heat pump repairs in Bournemouth: questions
Do you also cover Christchurch?
Yes. We arrange heat pump servicing and repairs in Christchurch, which is about 4 miles east of Bournemouth, and across Dorset.
How much does a visit cost in Bournemouth?
The rate for a service or fault-finding visit is agreed before anyone attends. Any repair is priced in writing before parts are ordered, so you decide before work goes ahead.
How often should a heat pump in Bournemouth be serviced?
Once a year is the usual recommendation, and many manufacturers make annual servicing a condition of the warranty. Check your warranty terms for the exact requirement.
How much does a heat pump repair cost?
Heat pump repairs have a typical range of £90–£1,100, including VAT, depending on the part and labour involved. Sensor replacements sit at the lower end, while control boards and refrigerant repairs on split systems sit higher. Every repair starts with a fault-finding visit, with a guide price of £90–£180 for the first hour, and the repair is priced before work goes ahead.
Why does my heat pump keep switching on and off?
Frequent starting and stopping, called short cycling, is usually caused by an oversized heat pump, low water flow, too many zones closing at once or controls set with too narrow a range. It reduces efficiency and wears components. An engineer can check the settings, flow rates and design, and can often improve it with control changes before any parts are needed.