- Area
- West Glamorgan
- Postcode district
- SA4
- Nation
- Wales
- Guide price
- From £90 inc VAT
- Visit
- Rate agreed in advance
Heat pump repairs in Gorseinon: what to expect
A heat pump that is serviced and set up properly keeps running efficiently for many years. Many heat pump faults trace back to settings, low pressure or a worn part rather than the heat pump itself, and those can usually be put right.
Across Gorseinon and West Glamorgan, refrigerant repairs on split systems are carried out by an F-gas certified engineer. Repairs in Gorseinon that need a part ordered are explained and priced before the engineer leaves.
When a heat pump shows an error, loses pressure or stops heating, an engineer diagnoses the cause and explains the repair and its cost before fixing it.
- Heat pumps showing an error code or fault light
- Outdoor units that have become noisy, iced up or keep switching on and off
- Systems losing pressure or needing frequent topping up
What's included
- Supply and fitting of replacement parts
- Reading of error history and operating data
- Testing of sensors, pumps, valves, pressures and electrics
- Refrigerant repairs by an F-gas certified engineer where needed
- System refill, venting and recommissioning after the repair
We repair heat pumps in Gorseinon whoever installed them, including older monobloc and split systems.
Grants and rules for heat pumps in Wales
Homes in Gorseinon can use the Boiler Upgrade Scheme, which applies in Wales as well as England: £7,500 towards an air source heat pump, or £9,000 when it replaces oil or LPG heating for installations from 21 July 2026 to 31 March 2027. The MCS-certified installer named in your quote applies and deducts the grant.
Guide prices for heat pump repairs in Gorseinon
These are guide prices including VAT. The rate for your visit in Gorseinon is confirmed before we book it, and any repair is priced in writing before parts are ordered.
| Repair | Guide price |
|---|---|
| Fault-finding visit and diagnosis | £90–£180 |
| Sensor or thermistor replacement | £120–£280 |
| Expansion vessel or pressure relief valve | £150–£350 |
| Circulating pump replacement | £250–£480 |
| Fan motor replacement | £300–£650 |
| Refrigerant leak repair and re-gas (split systems) | £350–£950 |
| Main control board (PCB) replacement | £450–£1,100 |
Inc VAT. The fault-finding rate is agreed before we attend; repairs are priced in writing before parts are ordered.
How long is the heating season in Gorseinon?
On the shortest day Gorseinon gets about 7 hours 48 minutes of daylight, with the noon sun around 15° up. The heating season runs from autumn into spring, so a heat pump that is sized correctly and set up with weather compensation does most of its work in steady, cool conditions.
What happens when you book in Gorseinon?
- Tell us the make if you know it, the error code or symptoms, and send photos of the unit and controller.
- We confirm the fault-finding rate and arrange a visit in Gorseinon.
- The engineer diagnoses the fault and gives you a written price for the repair.
- Parts are ordered once you agree, and the repair is completed and tested.
Heat pump repairs in Gorseinon: questions
What should I check before booking a visit in Gorseinon?
Note any error code on the controller, check the system pressure gauge if you have one, and make sure the outdoor unit is clear of leaves or snow. Photos of the unit and controller help.
Can you work on a heat pump in Gorseinon that someone else installed?
Yes. We arrange servicing and repairs for most air source heat pumps in Gorseinon, whoever fitted them. Tell us the make and model when you get in touch.
How much does a visit cost in Gorseinon?
The rate for a service or fault-finding visit is agreed before anyone attends. Any repair is priced in writing before parts are ordered, so you decide before work goes ahead.
Why does my heat pump keep switching on and off?
Frequent starting and stopping, called short cycling, is usually caused by an oversized heat pump, low water flow, too many zones closing at once or controls set with too narrow a range. It reduces efficiency and wears components. An engineer can check the settings, flow rates and design, and can often improve it with control changes before any parts are needed.
Is ice on my heat pump a fault?
Some frost on the outdoor unit in cold, damp weather is normal, and the unit clears it with regular defrost cycles, often releasing a little vapour. It becomes a fault when thick ice builds up and does not clear, or when ice blocks the fan. That can point to poor airflow, a failed sensor, drainage problems or low refrigerant, and needs checking.