- Area
- East Sussex
- Postcode district
- TN33
- Nation
- England
- Guide price
- From £120 inc VAT
- Visit
- Rate agreed in advance
What to know about heat pump servicing in Battle
A heat pump that is serviced and set up properly keeps running efficiently for many years. Many heat pump faults trace back to settings, low pressure or a worn part rather than the heat pump itself, and those can usually be put right.
Heat pumps in Battle that sit near trees or hedges often need their outdoor coil cleared of leaves at the annual service. Homes in Battle and across East Sussex can book servicing at a time of year that suits them, ideally before winter.
An annual service keeps a heat pump running efficiently, catches small faults early and is often a condition of the manufacturer's warranty.
- Heat pumps installed by another company that need a new servicing arrangement
- Heat pumps a year or more past installation
- Homes where running costs have crept up or rooms feel cooler than before
What's included
- Glycol or antifreeze protection test where fitted
- Refrigerant circuit checks on split systems by an F-gas certified engineer
- Cleaning of the outdoor unit coil, fan area and condensate drain
- Expansion vessel, pressure relief and water quality checks
- Unvented cylinder safety checks and legionella cycle check
Service visits in Battle include unvented cylinder safety checks alongside the heat pump itself.
Grants and rules for heat pumps in England
In England the Boiler Upgrade Scheme gives £7,500 towards an air source heat pump (£9,000 if it replaces oil or LPG, from 21 July 2026 to 31 March 2027), and since 28 April 2026 a valid EPC is no longer needed. The grant is applied for by the MCS-certified installer and shown as a deduction on your Battle quote.
Heat pump servicing costs around Battle
These are guide prices including VAT. The rate for your visit in Battle is confirmed before we book it, and any repair is priced in writing before parts are ordered.
| Visit | Guide price |
|---|---|
| Annual heat pump service | £120–£260 |
| Fault-finding visit (first hour) | £90–£190 |
Inc VAT. The rate for your visit is confirmed before booking.
Designing for Battle's winters
Battle sees roughly 7 hours 55 minutes of daylight in late December against 16 hours 32 minutes in June. Milder southern winters suit heat pumps well, though the system is still sized for a cold snap rather than an average day.
What happens when you book in Battle?
- Book a service and tell us roughly how old the system is.
- An engineer visits your Battle home and works through the service checklist.
- You receive a written record of the service and any recommendations.
- If a repair is needed, it is priced in writing before any work goes ahead.
Heat pump servicing in Battle: questions
Can you work on a heat pump in Battle that someone else installed?
Yes. We arrange servicing and repairs for most air source heat pumps in Battle, whoever fitted them. Tell us the make and model when you get in touch.
What should I check before booking a visit in Battle?
Note any error code on the controller, check the system pressure gauge if you have one, and make sure the outdoor unit is clear of leaves or snow. Photos of the unit and controller help.
How much does a visit cost in Battle?
The rate for a service or fault-finding visit is agreed before anyone attends. Any repair is priced in writing before parts are ordered, so you decide before work goes ahead.
Is servicing needed to keep my warranty valid?
Often, yes. Many manufacturer warranties require an annual service with a dated record, and some extended warranties require an approved installer. Manufacturer warranties pass to you, and the length depends on the make and model. Check your warranty documents, and keep every service record safe with your MCS certificate and handover pack.
Can you service a split system?
Yes. Split systems have refrigerant pipes running between the outdoor unit and an indoor unit, and checks on that refrigerant circuit must be done by an F-gas certified engineer. We arrange the service so a suitably certified engineer attends. The water side, controls and cylinder are checked in the same visit, just as on a monobloc system.