Air source heat pumps, surveyed, designed and installed· Free home survey for installation enquiries
0800 088 6341
Monobloc heat pumps
England · 10 towns

Monobloc heat pumps in Northumberland

We arrange air source heat pumps for homes throughout Northumberland, from the first heat loss survey to commissioning and annual servicing.

The trade-off is that the pipes between the outdoor unit and the house carry water, so they must be protected from freezing. That is done with glycol (an anti-freeze) in the system or with anti-freeze valves that release water from the outdoor pipework if it nears freezing, for example during a power cut in cold weather. Keeping the outdoor pipe run short and well insulated also helps efficiency.

For Northumberland terraces with small yards, the survey confirms the unit fits with the clearances it needs. In exposed spots around Northumberland, frost protection for the outdoor pipework is chosen with the site in mind. A survey in Northumberland checks the unit position, pipe route and clearance zones together for homes across Northumberland.

Who it suits

  • Houses and bungalows with outdoor space close to where pipes enter the home
  • Homes where the unit can sit within a short pipe run of the cylinder
  • Households that want to keep refrigerant work out of routine servicing
  • Owners who want the simplest installation, with no indoor refrigerant

Grants and rules for heat pumps in England

England

In England the Boiler Upgrade Scheme gives £7,500 towards an air source heat pump (£9,000 if it replaces oil or LPG, from 21 July 2026 to 31 March 2027), and since 28 April 2026 a valid EPC is no longer needed. The grant is applied for by the MCS-certified installer and shown as a deduction on your quote.

Installing heat pumps is zero-rated for VAT across the UK until 31 March 2027. Since 29 May 2025, permitted development in England allows up to two air source heat pumps on a house, each up to 1.5 m³, with no blanket 1 m boundary rule — the installation must still meet the MCS planning standards, including the noise check. Listed buildings, flats and some conservation-area positions need extra consent, which we check at survey.

Monobloc heat pumps prices in Northumberland

Here are typical prices for monobloc heat pumps in Northumberland, installed and including VAT. Use the guide price tool for a figure based on your home, then a survey confirms it in writing.

Monobloc heat pumps prices in Northumberland
HomeTypical sizeInstalled guide priceAfter £7,500 grant
1–2 bedroom flat or small terrace4–5 kW£9,400–£12,400£1,900–£4,900
2–3 bedroom terrace or semi5–7 kW£10,400–£13,350£2,900–£5,850
3 bedroom semi or small detached6–9 kW£11,900–£15,350£4,400–£7,850
4 bedroom detached8–12 kW£13,850–£17,800£6,350–£10,300
5+ bedroom or larger older house11–16 kW£16,350–£22,300£8,850–£14,800

Installed, inc VAT: unit, cylinder, controls, minor pipework and commissioning.

Towns we cover in Northumberland

We cover 10 towns in Northumberland for monobloc heat pumps. Each links to local guide prices and the grant position for England.

TownPostcode districtNearest townMidwinter daylight
BlythNE24Bedlington7 h 08 min
CramlingtonNE23Bedlington7 h 09 min
AshingtonNE63Bedlington7 h 08 min
BedlingtonNE22Cramlington7 h 08 min
AlnwickNE66Morpeth7 h 05 min
Berwick-upon-TweedTD15Alnwick7 h 00 min
HexhamNE46Prudhoe7 h 10 min
MorpethNE61Bedlington7 h 08 min
PontelandNE20Cramlington7 h 09 min
PrudhoeNE42Newburn7 h 10 min

Monobloc heat pumps questions

Do monobloc heat pumps need an F-gas engineer?

For a typical installation no refrigerant work is needed on site, because the refrigerant circuit is sealed in the outdoor unit at the factory. That is one reason monobloc installs are simpler. If the sealed circuit ever develops a fault or leak, any repair to it must be done by an F-gas certified engineer, as with every refrigerant system.

Is glycol or anti-freeze valves the better option?

Neither is right for every home. Glycol gives reliable frost protection without draining but slightly reduces efficiency and needs its concentration checked at servicing. Anti-freeze valves keep the system water plain but release water if pipes near freezing during a power cut, so the system then needs refilling. The installer recommends one based on the unit, pipe run and how exposed the site is.

Are monobloc heat pumps covered by grants?

Yes. Monobloc units are air-to-water heat pumps, so in England and Wales they are covered by the Boiler Upgrade Scheme grant of £7,500 for eligible homes, or £9,000 when replacing oil or LPG heating within the published dates. In Scotland, Home Energy Scotland funding requires an MCS-certified installer and products. There is no dedicated homeowner heat pump grant in Northern Ireland at present.

What refrigerant do monobloc heat pumps use?

Most use R32 or R290. R290 is propane, a natural refrigerant with a very low global warming impact, and some models use it to reach higher flow temperatures. Because R290 is flammable, manufacturers set clearance zones around the unit from openings such as windows, doors and drains, which the survey takes into account when choosing a position.

Ready to price your heat pump?

Use the guide price tool, or book a free home survey and fixed written quote.

CallGet a quote