There are two main ways to fit it. In new floors, such as an extension or a ground floor being dug out, pipes are set into a screed: a layer of sand and cement, or a flowing liquid mix, laid over insulation. In existing rooms, a low-profile or overlay system uses thin grooved boards laid on top of the current floor, raising it by a modest amount instead of breaking it up.
We coordinate with builders working in Cheshire so underfloor pipes are laid and tested before the screed goes down. Homeowners in Cheshire and across Cheshire can mix underfloor heating downstairs with radiators upstairs on one heat pump. Kitchen extensions in Cheshire are often the natural place to add underfloor heating when a heat pump goes in.
Who it suits
- Extensions, especially open-plan kitchen-diners with large glazed areas
- Rooms where wall space for radiators is scarce
- Self-builds and new floors where insulation and screed are going in anyway
- Homeowners who want even, gentle warmth with no radiators on show
Grants and rules for heat pumps in England
Homes in Cheshire can use the Boiler Upgrade Scheme, which takes £7,500 off the cost of an air source heat pump when it replaces fossil-fuel or electric heating. Replacing oil or LPG heating qualifies for £9,000 for installations from 21 July 2026 to 31 March 2027, and air-to-air systems for £2,500. The MCS-certified installer named in your quote applies for the grant and deducts it from the price.
Installing heat pumps is zero-rated for VAT across the UK until 31 March 2027. Since 29 May 2025, permitted development in England allows up to two air source heat pumps on a house, each up to 1.5 m³, with no blanket 1 m boundary rule — the installation must still meet the MCS planning standards, including the noise check. Listed buildings, flats and some conservation-area positions need extra consent, which we check at survey.
Underfloor heating with heat pumps prices in Cheshire
These are guide prices for Cheshire, installed and including VAT. Your final price is fixed in a written quote after the survey and depends on the heat loss of the house, the radiators that need changing and where the unit goes.
| Work | Guide price |
|---|---|
| Wet underfloor heating, one room | £1,500–£3,500 |
| Wet underfloor heating, whole ground floor | £5,000–£15,000 |
Installed, inc VAT. Floor finishes and screed drying time are confirmed at survey.
Towns we cover in Cheshire
We cover 18 towns in Cheshire for underfloor heating with a heat pump. Each links to local guide prices and the grant position for England.
| Town | Postcode district | Nearest town | Midwinter daylight |
|---|---|---|---|
| Warrington | WA1 | Widnes | 7 h 29 min |
| Chester | CH1 | Ellesmere Port | 7 h 31 min |
| Crewe | CW1 | Nantwich | 7 h 33 min |
| Ellesmere Port | CH65 | Chester | 7 h 30 min |
| Widnes | WA8 | Runcorn | 7 h 30 min |
| Runcorn | WA7 | Widnes | 7 h 30 min |
| Macclesfield | SK11 | Alderley Edge | 7 h 31 min |
| Northwich | CW9 | Winsford | 7 h 31 min |
| Winsford | CW7 | Middlewich | 7 h 31 min |
| Congleton | CW12 | Sandbach | 7 h 32 min |
| Wilmslow | SK9 | Alderley Edge | 7 h 30 min |
| Sandbach | CW11 | Crewe | 7 h 32 min |
| Nantwich | CW5 | Crewe | 7 h 33 min |
| Alderley Edge | SK9 | Wilmslow | 7 h 30 min |
| Frodsham | WA6 | Runcorn | 7 h 30 min |
| Knutsford | WA16 | Alderley Edge | 7 h 30 min |
| Middlewich | CW10 | Winsford | 7 h 31 min |
| Tarporley | CW6 | Winsford | 7 h 32 min |
Underfloor heating with a heat pump questions
How much will an overlay system raise my floor?
A low-profile overlay system typically adds around 15–25 mm for the boards, plus the thickness of the new floor finish. That can be enough to need door trimming, threshold strips and adjustments where the floor meets kitchen units or stairs. We measure these details at the survey so the build-up is agreed before work starts.
Can I heat just one room with underfloor heating?
Yes. A single room, such as a kitchen extension, can have its own underfloor zone connected to the heat pump alongside the radiators in the rest of the house. It needs its own thermostat and a manifold, which for one room can be compact. The design checks the room's heat loss so the floor can meet it at the system's flow temperature.
How long does a screed floor take before I can use the heating?
Screed needs to dry before the heating is used at full temperature and before most floor finishes are laid. Drying time depends on the screed type, depth and conditions, from around a week for some liquid screeds to several weeks or more for traditional sand and cement. The heating is then brought up gradually over several days to avoid cracking.
Is underfloor heating better than radiators with a heat pump?
Underfloor heating usually allows a lower flow temperature than radiators, which helps a heat pump run efficiently. That does not make radiators a poor choice: correctly sized radiators also work well, and they are far less disruptive to fit in existing rooms. Many homes use underfloor heating in an extension or on the ground floor and radiators elsewhere.