Underfloor heating can cover one room, an extension or the whole ground floor, and it works alongside radiators upstairs. We design it from the same room-by-room heat loss figures as the rest of the system, set out pipe spacing and zones for each room, and confirm which floor finishes will let the heat through.
Older houses around Merseyside with suspended timber floors can often take underfloor pipes between the joists. Kitchen extensions in Merseyside are often the natural place to add underfloor heating when a heat pump goes in. For homes in Merseyside with solid ground floors, a low-profile overlay system can avoid breaking up the existing floor.
Who it suits
- Rooms where wall space for radiators is scarce
- Self-builds and new floors where insulation and screed are going in anyway
- Homeowners who want even, gentle warmth with no radiators on show
- Extensions, especially open-plan kitchen-diners with large glazed areas
Grants and rules for heat pumps in England
In England the Boiler Upgrade Scheme gives £7,500 towards an air source heat pump (£9,000 if it replaces oil or LPG, from 21 July 2026 to 31 March 2027), and since 28 April 2026 a valid EPC is no longer needed. The grant is applied for by the MCS-certified installer and shown as a deduction on your quote.
Installing heat pumps is zero-rated for VAT across the UK until 31 March 2027. Since 29 May 2025, permitted development in England allows up to two air source heat pumps on a house, each up to 1.5 m³, with no blanket 1 m boundary rule — the installation must still meet the MCS planning standards, including the noise check. Listed buildings, flats and some conservation-area positions need extra consent, which we check at survey.
Underfloor heating with heat pumps prices in Merseyside
The ranges below are typical installed prices for homes in Merseyside, including VAT. A survey sets the exact figure, because two similar-looking houses in Merseyside can need quite different radiators and pipework.
| Work | Guide price |
|---|---|
| Wet underfloor heating, one room | £1,450–£3,400 |
| Wet underfloor heating, whole ground floor | £4,850–£14,550 |
Installed, inc VAT. Floor finishes and screed drying time are confirmed at survey.
Towns we cover in Merseyside
We cover 14 towns in Merseyside for underfloor heating with a heat pump. Each links to local guide prices and the grant position for England.
| Town | Postcode district | Nearest town | Midwinter daylight |
|---|---|---|---|
| Liverpool | L3 | Birkenhead | 7 h 29 min |
| Birkenhead | CH41 | Liverpool | 7 h 29 min |
| St Helens | WA10 | Prescot | 7 h 29 min |
| Southport | PR8 | Formby | 7 h 26 min |
| Wallasey | CH45 | Birkenhead | 7 h 29 min |
| Bootle | L21 | Wallasey | 7 h 28 min |
| Bebington | CH63 | Birkenhead | 7 h 30 min |
| Huyton | L36 | Prescot | 7 h 29 min |
| Kirkby | L32 | Maghull | 7 h 28 min |
| Prescot | L34 | Huyton | 7 h 29 min |
| Heswall | CH60 | Bebington | 7 h 30 min |
| Maghull | L31 | Kirkby | 7 h 28 min |
| Formby | L37 | Maghull | 7 h 27 min |
| Halewood | L26 | Huyton | 7 h 30 min |
Underfloor heating with a heat pump questions
How long does a screed floor take before I can use the heating?
Screed needs to dry before the heating is used at full temperature and before most floor finishes are laid. Drying time depends on the screed type, depth and conditions, from around a week for some liquid screeds to several weeks or more for traditional sand and cement. The heating is then brought up gradually over several days to avoid cracking.
How much will an overlay system raise my floor?
A low-profile overlay system typically adds around 15–25 mm for the boards, plus the thickness of the new floor finish. That can be enough to need door trimming, threshold strips and adjustments where the floor meets kitchen units or stairs. We measure these details at the survey so the build-up is agreed before work starts.
Can I put carpet over underfloor heating?
Yes, as long as the carpet and underlay together have a low tog rating, which measures how much they resist heat. For heat pump systems a combined figure of around 1.5 tog or less is a common target. Thick carpet on heavy underlay can cut output noticeably, so rooms with carpet may need closer pipe spacing.
Is underfloor heating better than radiators with a heat pump?
Underfloor heating usually allows a lower flow temperature than radiators, which helps a heat pump run efficiently. That does not make radiators a poor choice: correctly sized radiators also work well, and they are far less disruptive to fit in existing rooms. Many homes use underfloor heating in an extension or on the ground floor and radiators elsewhere.