Most heat pump cylinders are unvented, meaning they run at mains water pressure and give strong flow from every tap without a cold water tank in the loft. Unvented cylinders have safety controls that must be fitted and checked by someone qualified to work on them. We size the cylinder from your household and bathrooms, confirm your mains water supply can support it, and plan the space, pipework and discharge route at the survey.
We check mains water pressure and flow at each Mid Glamorgan property before choosing a cylinder. Cylinder sizes for Mid Glamorgan homes are based on the people living there and the bathrooms in daily use. Discharge pipe routes are planned at the survey so a Mid Glamorgan cylinder can drain safely to the outside.
Who it suits
- Homes with solar PV that want to store daytime electricity as hot water
- Larger families or homes with two or more bathrooms
- Homes replacing a combi boiler that need space found for a cylinder
- Every air-to-water heat pump installation, whatever the existing boiler
Grants and rules for heat pumps in Wales
In Wales the Boiler Upgrade Scheme gives £7,500 towards an air source heat pump (£9,000 if it replaces oil or LPG, from 21 July 2026 to 31 March 2027; £2,500 for air-to-air). The MCS-certified installer named in your quote applies to Ofgem for you, and the grant comes off your quote.
There is no VAT on installing a heat pump anywhere in the UK, Wales included, until 31 March 2027. Planning rules for heat pumps in Wales are set by the Welsh Government and differ from England's, so the surveyor checks the unit position against them.
Heat pump hot water cylinders prices in Mid Glamorgan
Here are typical prices for heat pump hot water cylinders in Mid Glamorgan, installed and including VAT. Use the guide price tool for a figure based on your home, then a survey confirms it in writing.
| Work | Guide price |
|---|---|
| Heat pump hot water cylinder (supplied and fitted) | £1,200–£2,200 |
Supplied and fitted, inc VAT. Included in every full system price.
Towns we cover in Mid Glamorgan
We cover 11 towns in Mid Glamorgan for heat pump hot water cylinders. Each links to local guide prices and the grant position for Wales.
| Town | Postcode district | Nearest town | Midwinter daylight |
|---|---|---|---|
| Bridgend | CF31 | Porthcawl | 7 h 49 min |
| Merthyr Tydfil | CF47 | Aberdare | 7 h 47 min |
| Pontypridd | CF37 | Llantrisant | 7 h 49 min |
| Aberdare | CF44 | Mountain Ash | 7 h 47 min |
| Caerphilly | CF83 | Pontypridd | 7 h 49 min |
| Maesteg | CF34 | Port Talbot | 7 h 48 min |
| Porthcawl | CF36 | Bridgend | 7 h 50 min |
| Bargoed | CF81 | Blackwood | 7 h 48 min |
| Llantrisant | CF72 | Pontypridd | 7 h 49 min |
| Mountain Ash | CF45 | Aberdare | 7 h 48 min |
| Tonypandy | CF40 | Pontypridd | 7 h 48 min |
Heat pump hot water cylinders questions
Can I keep my existing hot water cylinder with a heat pump?
Usually not. Cylinders designed for boilers have a small coil that cannot transfer heat quickly at heat pump temperatures, so the water would reheat slowly and efficiency would suffer. A heat pump cylinder has a much larger coil. The new cylinder can often go in the same cupboard, though, if there is enough height and floor space.
How much does a heat pump cylinder cost?
A heat pump hot water cylinder has a guide price of £1,200–£2,200, installed and including VAT. In a full heat pump installation the cylinder is already included in the system guide price, so this figure mainly applies where a cylinder is replaced on its own. Capacity, coil design and the pipework needed affect where your price sits.
Will I run out of hot water with a heat pump?
Not if the cylinder is sized to how your household uses hot water. Unlike a combi, hot water is stored, so very heavy use, such as several long showers back to back, can use up the stored volume before it reheats. Sizing for your busiest period, and timing reheats sensibly, avoids this for most homes.
I have a combi boiler. Where will the cylinder go?
Moving from a combi to a heat pump means finding space for a cylinder, usually somewhere around 600 mm square and up to about 2 m tall. Common choices are a bedroom or landing cupboard, a utility room, under the stairs or an integral garage. The surveyor looks at your layout and suggests options, including slimline models where space is tight.