- Area
- Perth and Kinross
- Postcode district
- PH3
- Nation
- Scotland
- Guide price
- From £90 inc VAT
- Visit
- Rate agreed in advance
What to know about heat pump repairs in Auchterarder
A heat pump that is serviced and set up properly keeps running efficiently for many years. Many heat pump faults trace back to settings, low pressure or a worn part rather than the heat pump itself, and those can usually be put right.
We repair heat pumps in Auchterarder whoever installed them, including older monobloc and split systems. Heat pump owners in Auchterarder can arrange a fault-finding visit at a rate agreed before an engineer attends.
When a heat pump shows an error, loses pressure or stops heating, an engineer diagnoses the cause and explains the repair and its cost before fixing it.
- Outdoor units that have become noisy, iced up or keep switching on and off
- Heat pumps installed by another company that need a second opinion
- Rooms or hot water not getting warm enough
What's included
- System refill, venting and recommissioning after the repair
- A clear explanation of the fault and a price for the repair before work goes ahead
- Refrigerant repairs by an F-gas certified engineer where needed
- Reading of error history and operating data
- Supply and fitting of replacement parts
Outdoor units in exposed spots around Auchterarder can ice more heavily, so siting is checked as part of any icing fault.
Grants and rules for heat pumps in Scotland
In Scotland, heat pump funding comes through Home Energy Scotland rather than the Boiler Upgrade Scheme: a grant of up to £7,500 (up to £1,500 extra for eligible rural and island homes) and an optional interest-free loan of up to £7,500. For an Auchterarder home, apply and receive the written offer before the installation date is fixed.
Heat pump repairs prices in Auchterarder
These are guide prices including VAT. The rate for your visit in Auchterarder is confirmed before we book it, and any repair is priced in writing before parts are ordered.
| Repair | Guide price |
|---|---|
| Fault-finding visit and diagnosis | £90–£180 |
| Sensor or thermistor replacement | £120–£280 |
| Expansion vessel or pressure relief valve | £150–£350 |
| Circulating pump replacement | £250–£480 |
| Fan motor replacement | £300–£660 |
| Refrigerant leak repair and re-gas (split systems) | £350–£960 |
| Main control board (PCB) replacement | £450–£1,100 |
Inc VAT. The fault-finding rate is agreed before we attend; repairs are priced in writing before parts are ordered.
How long is the heating season in Auchterarder?
On the shortest day Auchterarder gets only about 6 hours 53 minutes of daylight, with the sun around 10° up at noon. Long Scottish winters mean the heat pump runs for much of the year, so careful sizing, good controls and correctly sized radiators make a real difference.
How a visit works in Auchterarder
- Tell us the make if you know it, the error code or symptoms, and send photos of the unit and controller.
- We confirm the fault-finding rate and arrange a visit in Auchterarder.
- The engineer diagnoses the fault and gives you a written price for the repair.
- Parts are ordered once you agree, and the repair is completed and tested.
Heat pump repairs in Auchterarder: questions
Can you work on a heat pump in Auchterarder that someone else installed?
Yes. We arrange servicing and repairs for most air source heat pumps in Auchterarder, whoever fitted them. Tell us the make and model when you get in touch.
What should I check before booking a visit in Auchterarder?
Note any error code on the controller, check the system pressure gauge if you have one, and make sure the outdoor unit is clear of leaves or snow. Photos of the unit and controller help.
Will the engineer need access indoors as well as outside?
Usually yes. The outdoor unit, the hot water cylinder, the controls and the pipework and valves indoors are all part of the visit, so allow access to each.
Can you repair a heat pump installed by another company?
Yes. We carry out fault-finding and repairs on heat pumps installed by other companies, including monobloc and split systems. Tell us the make, model and approximate age when you get in touch, plus any error code shown. If the system is still under the manufacturer's warranty, it may be quicker to contact the original installer or manufacturer first.
Why does my heat pump keep switching on and off?
Frequent starting and stopping, called short cycling, is usually caused by an oversized heat pump, low water flow, too many zones closing at once or controls set with too narrow a range. It reduces efficiency and wears components. An engineer can check the settings, flow rates and design, and can often improve it with control changes before any parts are needed.