Underfloor heating can cover one room, an extension or the whole ground floor, and it works alongside radiators upstairs. We design it from the same room-by-room heat loss figures as the rest of the system, set out pipe spacing and zones for each room, and confirm which floor finishes will let the heat through.
Every underfloor design for West Glamorgan starts with the floor finish you plan to lay, from tiles to carpet. Older houses around West Glamorgan with suspended timber floors can often take underfloor pipes between the joists. Homeowners in West Glamorgan and across West Glamorgan can mix underfloor heating downstairs with radiators upstairs on one heat pump.
Who it suits
- Self-builds and new floors where insulation and screed are going in anyway
- Rooms where wall space for radiators is scarce
- Homeowners who want even, gentle warmth with no radiators on show
- Extensions, especially open-plan kitchen-diners with large glazed areas
Grants and rules for heat pumps in Wales
In Wales the Boiler Upgrade Scheme gives £7,500 towards an air source heat pump (£9,000 if it replaces oil or LPG, from 21 July 2026 to 31 March 2027; £2,500 for air-to-air). The MCS-certified installer named in your quote applies to Ofgem for you, and the grant comes off your quote.
There is no VAT on installing a heat pump anywhere in the UK, Wales included, until 31 March 2027. Planning rules for heat pumps in Wales are set by the Welsh Government and differ from England's, so the surveyor checks the unit position against them.
Underfloor heating with heat pumps prices in West Glamorgan
The ranges below are typical installed prices for homes in West Glamorgan, including VAT. A survey sets the exact figure, because two similar-looking houses in West Glamorgan can need quite different radiators and pipework.
| Work | Guide price |
|---|---|
| Wet underfloor heating, one room | £1,500–£3,500 |
| Wet underfloor heating, whole ground floor | £5,000–£15,000 |
Installed, inc VAT. Floor finishes and screed drying time are confirmed at survey.
Towns we cover in West Glamorgan
We cover 8 towns in West Glamorgan for underfloor heating with a heat pump. Each links to local guide prices and the grant position for Wales.
| Town | Postcode district | Nearest town | Midwinter daylight |
|---|---|---|---|
| Swansea | SA1 | Mumbles | 7 h 48 min |
| Neath | SA10 | Briton Ferry | 7 h 48 min |
| Briton Ferry | SA12 | Neath | 7 h 48 min |
| Gorseinon | SA4 | Swansea | 7 h 48 min |
| Clydach | SA6 | Pontardawe | 7 h 48 min |
| Mumbles | SA3 | Swansea | 7 h 49 min |
| Pontardawe | SA8 | Clydach | 7 h 47 min |
| Port Talbot | SA12 | Briton Ferry | 7 h 49 min |
Underfloor heating with a heat pump questions
Is underfloor heating better than radiators with a heat pump?
Underfloor heating usually allows a lower flow temperature than radiators, which helps a heat pump run efficiently. That does not make radiators a poor choice: correctly sized radiators also work well, and they are far less disruptive to fit in existing rooms. Many homes use underfloor heating in an extension or on the ground floor and radiators elsewhere.
How much does underfloor heating cost with a heat pump?
Wet underfloor heating for a whole ground floor has a guide price of £5,000–£15,000, installed and including VAT, and a single room has a guide price of £1,500–£3,500. The spread reflects floor type, area, whether an overlay or screed system is used and how much floor preparation is needed. Your written quote fixes the price after the survey.
Can I put carpet over underfloor heating?
Yes, as long as the carpet and underlay together have a low tog rating, which measures how much they resist heat. For heat pump systems a combined figure of around 1.5 tog or less is a common target. Thick carpet on heavy underlay can cut output noticeably, so rooms with carpet may need closer pipe spacing.
Can I heat just one room with underfloor heating?
Yes. A single room, such as a kitchen extension, can have its own underfloor zone connected to the heat pump alongside the radiators in the rest of the house. It needs its own thermostat and a manifold, which for one room can be compact. The design checks the room's heat loss so the floor can meet it at the system's flow temperature.