Air source heat pumps, surveyed, designed and installed· Free home survey for installation enquiries
0800 088 6341
Heat pump replacement
England · 15 towns

Heat pump replacement in North Yorkshire

We arrange air source heat pumps for homes throughout North Yorkshire, from the first heat loss survey to commissioning and annual servicing.

Heat pump replacement means removing an existing outdoor unit, and sometimes the cylinder and controls, and fitting a new heat pump sized and set up for the home as it is now. Air source heat pumps typically last 15–20 years, so systems fitted when the technology was newer to UK homes are reaching the point where repairs become harder to justify.

Across North Yorkshire and North Yorkshire, old units are removed with their refrigerant recovered by an F-gas certified engineer. Homes in North Yorkshire with a heat pump that never kept them warm can have the whole design checked before a new unit is chosen. We replace heat pumps in North Yorkshire whoever fitted the original system, including monobloc and split units.

Who it suits

  • Older units where parts are becoming hard to source
  • Oversized systems that short cycle and cost more to run than expected
  • Units that have failed with a major fault, such as a compressor failure
  • Heat pumps nearing the end of their typical life with rising repair costs

Grants and rules for heat pumps in England

England

Homes in North Yorkshire can use the Boiler Upgrade Scheme, which takes £7,500 off the cost of an air source heat pump when it replaces fossil-fuel or electric heating. Replacing oil or LPG heating qualifies for £9,000 for installations from 21 July 2026 to 31 March 2027, and air-to-air systems for £2,500. The MCS-certified installer named in your quote applies for the grant and deducts it from the price.

Heat pump replacement prices in North Yorkshire

These are guide prices including VAT. The rate for your visit in North Yorkshire is confirmed before we book it, and any repair is priced in writing before parts are ordered.

Heat pump replacement prices in North Yorkshire
WorkInstalled guide price
Replacing an old outdoor unit like-for-like£6,000–£9,500
Full system replacement, 2–3 bedroom terrace or semi£10,500–£13,500
Full system replacement, 3 bedroom semi or small detached£12,000–£15,500
Full system replacement, 4 bedroom detached£14,000–£18,000

Installed, inc VAT. Grant funding rarely applies to replacing a heat pump, so these prices are shown without any deduction; we check eligibility at survey.

Towns we cover in North Yorkshire

We cover 15 towns in North Yorkshire for heat pump replacement. Each links to local guide prices and the grant position for England.

TownPostcode districtNearest townMidwinter daylight
YorkYO1Selby7 h 23 min
MiddlesbroughTS1Thornaby-on-Tees7 h 15 min
HarrogateHG2Knaresborough7 h 22 min
ScarboroughYO12Whitby7 h 19 min
RedcarTS10Middlesbrough7 h 15 min
SelbyYO8Howden7 h 25 min
Thornaby-on-TeesTS17Yarm7 h 16 min
YarmTS15Thornaby-on-Tees7 h 16 min
NorthallertonDL7Thirsk7 h 18 min
RiponHG4Knaresborough7 h 20 min
KnaresboroughHG5Harrogate7 h 22 min
MaltonYO17Pocklington7 h 20 min
SkiptonBD23Keighley7 h 23 min
ThirskYO7Northallerton7 h 19 min
WhitbyYO22Scarborough7 h 16 min

Heat pump replacement questions

Can I get a grant to replace my heat pump?

Usually not. In England and Wales, the Boiler Upgrade Scheme cannot normally fund a home that has already been funded for a heat pump, and it is aimed at replacing fossil-fuel or electric heating. Your circumstances may differ, so we check eligibility before quoting. In Scotland, check Home Energy Scotland's criteria. Northern Ireland has no dedicated grant at present.

What happens to my old heat pump?

The old outdoor unit is removed and disposed of responsibly. Its refrigerant is recovered first, which must be done by an F-gas certified engineer, and metals and components are recycled where facilities allow. If the old cylinder or controls are replaced too, they are removed at the same time, and pipework that is no longer needed is capped or taken out.

Will a new heat pump fit where the old one was?

Sometimes. A new unit may be a different size, weight or shape and may have different clearance requirements, so the existing base and position are checked at survey. The MCS noise assessment is carried out for the new unit, and a different position may be suggested if it improves performance or reduces sound at neighbouring windows.

Can I replace just the outdoor unit?

Often, yes, if the rest of the system is sound and correctly designed. The cylinder, controls and radiators can stay where they are compatible with the new unit. Some older cylinders and controllers do not work with a new heat pump, and the survey checks this. If the original design was the problem, replacing only the unit will not fix it.

Ready to price your heat pump?

Use the guide price tool, or book a free home survey and fixed written quote.

CallGet a quote