A hybrid heat pump is an air-to-water heat pump installed alongside an existing gas, LPG or oil boiler, with a controller that decides which one supplies heat at any moment. Typically the heat pump covers mild and moderate weather, and the boiler takes over or helps on the coldest days, or whenever it is cheaper to run on the prices entered into the controller.
For County Londonderry homes with a boiler that is still fairly new, a hybrid lets a heat pump take on much of the heating now. In County Londonderry, the outdoor unit of a hybrid needs the same airflow and siting care as any heat pump. Combi homes in County Londonderry with no space for a cylinder can look at a hybrid that keeps the combi for hot water.
Who it suits
- Large or hard-to-insulate homes where a full heat pump is difficult for now
- Homes with a fairly new boiler the owner wants to keep using
- Combi homes with no room for a cylinder
- Owners who want a stepping stone towards a full heat pump later
Grants and rules for heat pumps in Northern Ireland
Northern Ireland does not have a dedicated heat pump grant for homeowners at present, and the Boiler Upgrade Scheme does not apply here. Heat pumps have sometimes been funded through the Northern Ireland Sustainable Energy Programme, so it is worth checking what is open when you enquire about a home in County Londonderry.
There is no VAT on installing a heat pump in Northern Ireland until 31 March 2027, the same as in Great Britain. Planning and building control here follow Northern Ireland's own rules, so the survey checks the unit position against them.
Hybrid heat pumps prices in County Londonderry
Here are typical prices for hybrid heat pumps in County Londonderry, installed and including VAT. Use the guide price tool for a figure based on your home, then a survey confirms it in writing.
| System | Installed guide price |
|---|---|
| Hybrid heat pump alongside an existing boiler | £6,800–£10,650 |
Installed, inc VAT.
Towns we cover in County Londonderry
We cover 7 towns in County Londonderry for hybrid heat pumps. Each links to local guide prices and the grant position for Northern Ireland.
| Town | Postcode district | Nearest town | Midwinter daylight |
|---|---|---|---|
| Derry/Londonderry | BT48 | Limavady | 7 h 10 min |
| Coleraine | BT52 | Portstewart | 7 h 08 min |
| Dungiven | BT47 | Limavady | 7 h 11 min |
| Limavady | BT49 | Dungiven | 7 h 09 min |
| Maghera | BT46 | Magherafelt | 7 h 12 min |
| Magherafelt | BT45 | Maghera | 7 h 13 min |
| Portstewart | BT55 | Coleraine | 7 h 08 min |
Hybrid heat pumps questions
Does a hybrid switch between heat sources automatically?
Yes. The hybrid controller follows rules set at commissioning: it might switch to the boiler below a chosen outdoor temperature, compare running costs using the prices you enter, or prioritise lower carbon. Some systems run both together in very cold weather. The installer sets these for your home and shows you how to adjust them when tariffs change.
Can I get the Boiler Upgrade Scheme grant for a hybrid heat pump?
No. In England and Wales hybrid systems are not eligible for the Boiler Upgrade Scheme, because the scheme requires the heat pump to meet the home's full heating and hot water needs on its own. If a grant matters to your budget, a full air-to-water heat pump is the option that can qualify. In Scotland and Northern Ireland we check at survey what, if any, funding applies.
Will a hybrid heat pump lower my bills?
It can reduce how much gas, LPG or oil you burn, but the effect depends on how the controller is set, your insulation, your tariff and fuel prices. You keep a boiler to service and, on mains gas, the standing charge. We do not promise a figure; instead the survey gives an estimate for your home comparing a hybrid with a full heat pump.
Is a hybrid a good step towards a full heat pump?
It can be, if the outdoor unit and pipework are sized with a future full system in mind. Later, once insulation has improved or radiators have been upgraded, the boiler can be removed and the system converted, provided the heat pump is large enough for the full load. Raise this at survey so the design leaves room to change.